Effect of joint line remnant on fatigue lifetime of friction stir welded Al–Cu–Li alloy

Abstract The effect of joint line remnant (JLR) on the fatigue lifetime of friction stir welds of a 2198 Al alloy in T851 condition has been assessed experimentally. The base material, sound welds (welded in one sheet) and welds with JLR (produced via welding of two sheets with a natural oxide layer) have been investigated. A strong decrease in microhardness is found for the weak weld zone that is consistent with the reduction in tensile properties compared to the base material: 45% in yield strength and 22% in ultimate tensile strength. The fatigue strengths of sound and JLR bearing welds at 100 000 cycles (R=0·1) are reduced by 10 and 15% respectively compared to the base material. Only for one-third of the JLR bearing specimens, the fatigue crack initiated in regions close to the JLR and this without reduction in fatigue lifetime.

[1]  P. Threadgill,et al.  Friction stir welding of aluminium alloys , 2009 .

[2]  Anthony P. Reynolds,et al.  Visualisation of material flow in autogenous friction stir welds , 2000 .

[3]  Livan Fratini,et al.  Material flow in FSW of AA7075–T6 butt joints: Numerical simulations and experimental verifications , 2006 .

[4]  Thomas H. North,et al.  Intermixing in Dissimilar Friction Stir Spot Welds , 2007 .

[5]  Robert L. Taylor,et al.  Microstructural studies of friction stir welds in 2024-T3 aluminum , 2002 .

[6]  A. Reynolds,et al.  Visualization of the material flow in AA2195 friction-stir welds using a marker insert technique , 2001 .

[7]  Pedro Vilaça,et al.  Material flow in heterogeneous friction stir welding of thin aluminium sheets: Effect of shoulder geometry , 2008 .

[8]  Jesper Henri Hattel,et al.  Material flow in butt friction stir welds in AA2024-T3 , 2006 .

[9]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[10]  A. Gerlich,et al.  Material flow and intermixing during dissimilar friction stir welding , 2008 .

[11]  R. Fonda,et al.  Development of grain structure during friction stir welding , 2004 .

[12]  Rajiv S. Mishra,et al.  Process forces during friction stir welding of aluminium alloys , 2009 .

[13]  Z. Chen,et al.  On the forming mechanism of banded structures in aluminium alloy friction stir welds , 2008 .

[14]  S. Muthukumaran,et al.  Multi-layered metal flow and formation of onion rings in friction stir welds , 2008 .

[15]  A. Gerlich,et al.  Local melting and cracking in Al 7075-T6 and Al 2024-T3 friction stir spot welds , 2007 .

[16]  L. Murr,et al.  Solid-state flow visualization in the friction-stir welding of 2024 Al to 6061 Al , 1999 .

[17]  J. A. Schneider,et al.  Characterization of plastic flow and resulting microtextures in a friction stir weld , 2004 .

[18]  P. Prangnell,et al.  Grain structure formation during friction stir welding observed by the ‘stop action technique’ , 2005 .

[19]  M. Ball,et al.  Characterisation of microstructure and texture in friction stir welded joints of 5754 and 5182 aluminium alloy sheets , 2001 .