Performance characteristics of the deep space 1 flight spare ion thruster long duration test, the first 21,300 hours of operation

A long duration test of the DSl flight spare ion thruster (FT2) is presently being conducted at the Jet Propulsion Laboratory. To, date the thruster has accumulated over 23,500 hours of operation, and 190 kg of Xenon propellant, over 230% of the initial design life. The primary objectives of the test include the processing of 200 kg of Xenon propellant, the identification of unknown failure modes, the characterization and drivers of these failure modes, and to measure performance degradation as the thruster wears. The test is fitted with an extensive array of diagnostics to measure engine wear and performance degradation. To date the most notable erosion processes include severe discharge cathode keeper erosion, accelerator grid erosion, reduction in electrical isolation of the neutralizer assembly, and deposit formation within the neutralizer orifice, reducing margin from plume mode. Over the past 23,500 hours of operation, performance degradation has been minimal, and it is anticipated that the above erosion processes will not preclude the thruster from processing over 200 kg of Xenon.

[1]  Michael J. Patterson,et al.  NASA 30 Cm Ion Thruster Development Status , 1994 .

[2]  Roger M. Myers,et al.  A 100 Hour Wear Test of the NASA NSTAR Ion Thruster , 1996 .

[3]  Michael J. Patterson,et al.  The 2.3 kW Ion Thruster Wear Test , 1995 .

[4]  Gani B. Ganapathi,et al.  ANA 99-2273 Post-Launch Performance Characterization of the Xenon Feed -System on Deep Space One , 1999 .

[5]  Michael J. Patterson,et al.  Demonstration of the NSTAR ion propulsion system on the Deep Space One mission , 2001 .

[6]  J. E. Polk,et al.  The Effect of Engine Wear on Performance in the NSTAR 8000 Hour Ion Engine Endurance Test , 1997 .

[7]  John R. Anderson,et al.  Results of an On-Going Long Duration Ground Test of the DS1 Flight Spare Engine , 1999 .

[8]  J. Sovey.  In Situ, Time-Resolved Accelerator Grid Erosion Measurements in the NSTAR 8000 Hour Ion Engine Wear Test , 1997 .

[9]  John R. Anderson,et al.  An overview of the results from an 8200 hour wear test of the NSTAR ion thruster , 1999 .

[10]  V. K. Rawlin,et al.  Operation of the J-series thruster using inert gas , 1982 .

[11]  J. Polk,et al.  NSTAR flight thruster qualification testing , 1998 .

[12]  John R. Anderson,et al.  Performance of the NSTAR ion propulsion system on the Deep Space One mission , 2001 .

[13]  John R. Brophy,et al.  Methods for Cryopumping Xenon , 1996 .

[14]  James E. Polk,et al.  Performance characteristics of the NSTAR ion thruster during an on-going long duration ground test , 2000, 2000 IEEE Aerospace Conference. Proceedings (Cat. No.00TH8484).

[15]  Michael J. Patterson,et al.  Thermographic investigation of 3.2 mm diameter orificed hollow cathodes , 1998 .

[16]  John R. Brophy,et al.  Behavior of the thrust vector in the NSTAR ion thruster , 1998 .

[17]  James E. Polk,et al.  In-flight performance of the NSTAR ion propulsion system on the Deep Space One mission , 2000, 2000 IEEE Aerospace Conference. Proceedings (Cat. No.00TH8484).