Guided Wave Beamsteering using MFC Phased Arrays for Structural Health Monitoring: Analysis and Experiment

Phased array beamsteering is an effective tool for damage detection and assessment method in a guided wave structural health monitoring system. Monolithic piezoceramic (PZT) actuators have been widely utilized for beamsteering by assuming omnidirectional point sources for each actuator. However, this assumption can lead to erroneous results for a phased array of actuators with anisotropic actuation, such as macro-fiber composites (MFC). The MFC actuators are investigated in this research for beamsteering considering the main lobe width, main lobe magnitude, and side lobe levels and compared to equivalently sized PZT actuators. Analytical models of the MFC and PZT actuators attached to an isotropic plate structure are presented and the genetic algorithm is used to determine the optimal timing sequences of the phased array elements for beamforming enhancement. The analysis results show that the MFC phased arrays have reduced the main lobe width and side lobe levels compared to the PZT phased arrays for a range of beamsteering angles. The area ratios of the MFC arrays are also found to be greater than the PZT arrays for these beamsteering angles. Experiments using the PZT and MFC phased arrays on an aluminum plate are performed and compared to the analysis results. The experiment results agree with the analysis results and demonstrate improved beamsteering of the MFC phased arrays for specific applications.

[1]  Joseph L. Rose,et al.  A Baseline and Vision of Ultrasonic Guided Wave Inspection Potential , 2002 .

[2]  Hoon Sohn,et al.  Overview of Piezoelectric Impedance-Based Health Monitoring and Path Forward , 2003 .

[3]  Shi-Chang Wooh,et al.  A Simulation Study of the Beam Steering Characteristics for Linear Phased Arrays , 1999 .

[4]  Lingyu Yu,et al.  Using Phased Array Technology and Embedded Ultrasonic Structural Radar for Active Structural Health Monitoring and Nondestructive Evaluation , 2005 .

[5]  A. Jeffrey.  Complex Analysis and Applications , 1991 .

[6]  Daniel J. Inman,et al.  Towards autonomous sensing , 2006, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[7]  Yi-Qing Ni,et al.  Technology developments in structural health monitoring of large-scale bridges , 2005 .

[8]  Carlos E. S. Cesnik,et al.  Finite-dimensional piezoelectric transducer modeling for guided wave based structural health monitoring , 2005 .

[9]  Daniel J. Inman,et al.  An Integrated Health Monitoring Technique Using Structural Impedance Sensors , 2000 .

[10]  V. Giurgiutiu.  Tuned Lamb Wave Excitation and Detection with Piezoelectric Wafer Active Sensors for Structural Health Monitoring , 2005 .

[11]  Thomas Daue,et al.  Overview on macrofiber composite applications , 2006, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[12]  T. S. Barry,et al.  Lamb Wave Assessment of Fatigue and Thermal Damage in Composites , 1998 .

[13]  W. Staszewski,et al.  Modelling of Lamb waves for damage detection in metallic structures: Part II. Wave interactions with damage , 2003 .

[14]  Andrei N Zagrai,et al.  Damage Identification in Aging Aircraft Structures with Piezoelectric Wafer Active Sensors , 2004 .

[15]  J. Miklowitz,et al.  The Theory of Elastic Waves and Waveguides , 1979 .

[16]  E. Crawley,et al.  Use of piezoelectric actuators as elements of intelligent structures , 1987 .

[17]  Lingyu Yu,et al.  In-Situ Optimized PWAS Phased Arrays for Lamb Wave Structural Health Monitoring , 2007 .

[18]  Ed Ginzel,et al.  Review of Ultrasonic Phased Arrays for Pressure Vessel and Pipeline Weld Inspections , 2005 .

[19]  Joseph L. Rose,et al.  Active health monitoring of an aircraft wing with embedded piezoelectric sensor/actuator network: I. Defect detection, localization and growth monitoring , 2007 .

[20]  Fu-Kuo Chang,et al.  Detection of bolt loosening in C–C composite thermal protection panels: I. Diagnostic principle , 2006 .

[21]  Shi-Chang Wooh,et al.  Beam focusing behavior of linear phased arrays , 2000 .

[22]  Carlos E. S. Cesnik,et al.  3-D Elasticity-based Modeling of Anisotropic Piezocomposite Transducers for Guided Wave Structural Health Monitoring , 2007 .

[23]  Daniel J. Inman,et al.  Detection of Corrosion Using Piezoelectric Impedance-Based Structural Health Monitoring , 2006 .

[24]  P.D. Wilcox,et al.  Omni-directional guided wave transducer arrays for the rapid inspection of large areas of plate structures , 2003, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[25]  Douglas E. Adams,et al.  Biologically inspired structural diagnostics through beamforming with phased transducer arrays , 2005 .

[26]  Paul H. Mirick,et al.  Low-cost piezocomposite actuator for structural control applications , 2000, Smart Structures.

[27]  Constantine A. Balanis,et al.  Antenna Theory: Analysis and Design , 1982 .