Performance of a solid oxide fuel cell couple operated via in situ catalytic partial oxidation of n-butane

Abstract The operation of a pair of anode-to-anode-facing solid oxide fuel cells (SOFCs) via in situ catalytic partial oxidation (CPO) of n-butane was investigated. In this simple “no-chamber” setup, butane is partially oxidized by heterogeneous reactions inside the porous anodes, providing processed fuel and the heat required for SOFC operation. The cell couple yielded a power density of up to 270 mW cm−2, and the maximum total power obtained was 1.2 W with cell sizes of 13 mm × 23 mm. The maximum electrical efficiency was 1.3%. High CO concentrations of up to 1000 ppm were detected in the exhaust gas, indicating that the cell couple could not efficiently consume the complete provided fuel. A flame, lit at the exhaust, minimized the carbon monoxide level while having insignificant influence on the cell performance. Thermal insulation of the cell couple improved the output remarkably, showing the strong influence of temperature on cell performance. The two cells had a distance of only 2 mm, suggesting a potential for high volumetric power densities in multi-cell configurations for a self-sustained combined heat and power system.

[1]  Raymond J. Gorte,et al.  An Examination of Carbonaceous Deposits in Direct-Utilization SOFC Anodes , 2004 .

[2]  Suttichai Assabumrungrat,et al.  Thermodynamic analysis of carbon formation in a solid oxide fuel cell with a direct internal reformer fuelled by methanol , 2005 .

[3]  T. Inagaki,et al.  Direct Internal Steam Reforming at SOFC Anodes Composed of NiO – SDC Composite Particles , 2007 .

[4]  Caine M. Finnerty,et al.  Carbon formation on and deactivation of nickel-based/zirconia anodes in solid oxide fuel cells running on methane , 1998 .

[5]  David G. Goodwin,et al.  Numerical Study of Heterogeneous Reactions in an SOFC Anode With Oxygen Addition , 2007, ECS Transactions.

[6]  Taeyoon Kim,et al.  A study of carbon formation and prevention in hydrocarbon-fueled SOFC , 2006 .

[7]  J. Kwok,et al.  GDC-Impregnated ( La0.75Sr0.25 ) ( Cr0.5Mn0.5 ) O3 Anodes for Direct Utilization of Methane in Solid Oxide Fuel Cells , 2006 .

[8]  Zongping Shao,et al.  A high-performance no-chamber fuel cell operated on ethanol flame , 2008 .

[9]  Takashi Hibino,et al.  Recent advances in single-chamber solid oxide fuel cells: A review , 2007 .

[10]  L. Gauckler,et al.  Engineering of Solid Oxide Fuel Cells with Ceria‐Based Electrolytes , 1998 .

[11]  Sano,et al.  A low-operating-temperature solid oxide fuel cell in hydrocarbon-Air mixtures , 2000, Science.

[12]  R. Kikuchi,et al.  Internal Reforming of SOFCs Carbon Deposition on Fuel Electrode and Subsequent Deterioration of Cell , 2007 .

[13]  Anthony M. Dean,et al.  Comparison of conversion and deposit formation of ethanol and butane under SOFC conditions , 2006 .

[14]  Wolfgang G. Bessler,et al.  A direct-flame solid oxide fuel cell (DFFC) operated on methane, propane, and butane , 2007 .

[15]  Michio Horiuchi,et al.  Electrochemical Power Generation Directly from Combustion Flame of Gases, Liquids, and Solids , 2004 .

[16]  R. E. Hayes,et al.  Introduction to Catalytic Combustion , 1998 .

[17]  R. C. Weast.  CRC Handbook of Chemistry and Physics , 1973 .

[18]  Ludwig J. Gauckler,et al.  Thermodynamic Equilibrium of Single-Chamber SOFC Relevant Methane–Air Mixtures , 2006 .

[19]  J. Hertz,et al.  Nanocomposite Platinum–Yttria Stabilized Zirconia Electrode and Implications for Micro-SOFC Operation , 2007 .

[20]  S. Barnett,et al.  Direct operation of solid oxide fuel cells with methane fuel , 2005 .

[21]  Vinod M. Janardhanan,et al.  Non-commercial Research and Educational Use including without Limitation Use in Instruction at Your Institution, Sending It to Specific Colleagues That You Know, and Providing a Copy to Your Institution's Administrator. All Other Uses, Reproduction and Distribution, including without Limitation Comm , 2022 .

[22]  Zongping Shao,et al.  A thermally self-sustained micro solid-oxide fuel-cell stack with high power density , 2005, Nature.

[23]  Piotr Jasinski,et al.  Impedance spectroscopy of single chamber SOFC , 2004 .

[24]  O. Deutschmann,et al.  Rational modeling of the CPO of methane over platinum gauze: Elementary gas-phase and surface mechanisms coupled with flow simulations , 2007 .

[25]  Ilan Riess,et al.  On the single chamber solid oxide fuel cells , 2008 .

[26]  Michel Meunier,et al.  Operating Conditions of a Single-Chamber SOFC , 2004 .

[28]  R. Kikuchi,et al.  Effect of precious metal addition to Ni-YSZ cermet on reforming of CH4 and electrochemical activity as SOFC anode , 2003 .

[29]  Ilan Riess,et al.  Mixed ionic–electronic conductors—material properties and applications , 2003 .