With the increase of domestic gas consumption in cities and towns in China, gas explosion accidents happened rather frequently, and many structures were damaged greatly. Rational physical design could protect structures from being destroyed, but the character of explosion load must be learned firstly by establishing a correct mechanical model to simulate vented gas explosions. The explosion process has been studied for many years towards the safety of chemical industry equipments. The key problem of these studies was the equations usually involved some adjustable parameters that must be evaluated by experimental data, and the procedure of calculation was extremely complicated, so the reliability of these studies was seriously limited. Based on these studies, a simple mathematical model was established in this paper by using energy conservation, mass conservation, gas state equation, adiabatic compression equation and gas venting equation. Explosion load must be estimated by considering the room layout; the rate of pressure rise was then corrected by using a turbulence factor, so the pressure-time curve could be obtained. By using this method, complicated calculation was avoided, while experimental and calculated results fitted fairly well. Some pressure-time curves in a typical rectangular room were calculated to investigate the influences of different ignition locations, gas thickness, concentration, room size and venting area on the explosion pressure. The results indicated that: it was the most dangerous condition when being ignited in the geometry centre of the room; the greater the burning velocity, the worse the venting effect; the larger the venting pressure, the higher the peak pressure; the larger the venting area, the lower the peak pressure.
[1]
P. Wolański,et al.
A new phenomenological model of gas explosion based on characteristics of flame surface
,
2007
.
[2]
M. Haq,et al.
Turbulent burning velocity, burned gas distribution, and associated flame surface definition
,
2003
.
[3]
T. Hirano,et al.
Venting of deflagrations: Hydrocarbon-air and hydrogen-air systems
,
2000
.
[4]
R. I. Soloukhin,et al.
Flame Acceleration of Propane-Air in a Large-Scale Obstructed Tube
,
1985
.
[5]
Bjørn H. Hjertager,et al.
FLAME ACCELERATION OF PROPANE-AIR IN A LARGE-SCALE OBSTRUCTED TUBE
,
1984
.
[6]
Lu Jie.
Study on flame propagation and accelerationmechanism of city coal gas
,
2004
.
[7]
R. Kumar,et al.
Vented Explosion of Hydrogen-Air Mixtures in a Large Volume
,
1989
.
[8]
Ritsu Dobashi,et al.
Experimental study on gas explosion behavior in enclosure
,
1997
.
[9]
Norbert J. Delatte,et al.
Ronan Point Apartment Tower Collapse and its Effect on Building Codes
,
2005
.
[10]
Ulrich Krause,et al.
Comparison of empirical and semi-empirical calculation methods for venting of gas explosions
,
2001
.
[11]
冯长根,et al.
Simulation Analysis of Indoor Gas Explosion Damage
,
2003
.
[12]
P. Canu,et al.
Vented gas deflagrations a detailed mathematical model tuned on a large set of experimental data
,
1990
.
[13]
T. Hirano,et al.
Modeling of vented hydrogen-air deflagrations and correlations for vent sizing
,
1999
.