Tungaloy Ceramic Cutting Tools at Interrupted Machninig
暂无分享,去创建一个
The paper deals with testing of ceramic cutting tools with an interrupted machining. Tests have been performed on fixture – interrupted cut simulator constructed at Department of Machining and Assembly, FME, VSB-TU Ostrava within the scope of the Czech Science Foundation project. The criterion of tool wear is either destruction of cutting tool or 6000 shocks. Testing cutting tool material used in this research is ceramic cutting tool produced by Tungaloy Company. Tested machined materials are 13MoCrV6 and C45 steels. The cutting speeds (408 and 580 m/min) and cutting feeds (0.15; 0.2; 0.25 and 0.3 mm) are investigated with variable parameters whereas the cutting depth is a constant parameter. The pictures of index-able inserts and graphs of dependence at variable cutting speed and cutting feed are shown as a result of a conducted investigation.
[1] Anton Panda,et al. Accompanying phenomena in the cutting zone machinability during turning of stainless steels , 2009 .
[2] Chun-Hong Park,et al. Tool wear control in single-crystal diamond cutting of steel by using the ultra-intermittent cutting method , 2009 .
[3] Robert Čep,et al. Chip Formation Analysis During Hard Turning , 2008 .
[4] Jan Reiner. Zkoušky nástrojů z řezné keramiky na simulátoru přerušovaného řezu , 2009 .