Electroplated Ni-CNT Nanocomposite for Micromechanical Resonator Applications

In this letter, electroplated Ni-CNT nanocomposite is synthesized and utilized as a structural material for micromechanical resonator fabrication. Pretreated by sulfate sodium dodecyl, carbon nanotubes (CNTs) disperse well in electrolyte and can be incorporated in an electroplated Ni film. Clamped-clamped beam resonators fabricated using the nanocomposite show 27% resonant frequency enhancement (from 498.75 to 634.72 kHz). Meanwhile, the Q factors of 781 and 760 for Ni and Ni-CNT nanocomposite resonators, which are comparable with the prior art, indicate that the anchor loss could dominate the Q performance of the beam resonators.

[1]  Wan-Thai Hsu.  Reliability of Silicon Resonator Oscillators , 2006, 2006 IEEE International Frequency Control Symposium and Exposition.

[2]  C. Nguyen,et al.  High-Q HF microelectromechanical filters , 2000, IEEE Journal of Solid-State Circuits.

[3]  C. Nguyen,et al.  Frequency-selective MEMS for miniaturized low-power communication devices , 1999 .

[4]  Zeying Ren,et al.  Nickel Vibrating Micromechanical Disk Resonator with Solid Dielectric Capacitive-Transducer Gap , 2006, 2006 IEEE International Frequency Control Symposium and Exposition.

[5]  A. Partridge,et al.  MEMS Oscillators for High Volume Commercial Applications , 2007, TRANSDUCERS 2007 - 2007 International Solid-State Sensors, Actuators and Microsystems Conference.

[6]  Weileun Fang,et al.  Ni-carbon nanotubes nanocomposite for robust microelectromechanical systems fabrication , 2006 .

[7]  Ark-Chew Wong,et al.  VHF free-free beam high-Q micromechanical resonators , 2000, Journal of Microelectromechanical Systems.

[8]  Wan-Thai Hsu.  Vibrating RF MEMS for Timing and Frequency References , 2006, 2006 IEEE MTT-S International Microwave Symposium Digest.

[9]  Tomoyuki Sato,et al.  Fabrication of Nickel–Multiwalled Carbon Nanotube Composite Films with Excellent Thermal Conductivity by an Electrodeposition Technique , 2006 .

[10]  Yu-Ting Cheng,et al.  Synthesis and characterization of Ni-P-CNT's nanocomposite film for MEMS applications , 2005 .

[11]  Yong-Hwa Park,et al.  High-fidelity modeling of MEMS resonators. Part I. Anchor loss mechanisms through substrate , 2004, Journal of Microelectromechanical Systems.

[12]  J. Kiihamaki,et al.  Stability of wafer level vacuum encapsulated single-crystal silicon resonators , 2005, The 13th International Conference on Solid-State Sensors, Actuators and Microsystems, 2005. Digest of Technical Papers. TRANSDUCERS '05..

[13]  Q. Xue,et al.  Investigation of tribological properties of polyimide/carbon nanotube nanocomposites , 2004 .

[14]  Quanfang Chen,et al.  Mechanical strength of carbon nanotube–nickel nanocomposites , 2007 .

[15]  J. Lahann,et al.  Fully monolithic CMOS nickel micromechanical resonator oscillator , 2008, 2008 IEEE 21st International Conference on Micro Electro Mechanical Systems.

[16]  J. Byun,et al.  Electrodeposition and mechanical properties of Ni–carbon nanotube nanocomposite coatings , 2008 .

[17]  R. Howe,et al.  Polycrystalline silicon-germanium films for integrated microsystems , 2003 .

[18]  H. Wagner,et al.  Evaluation of Young’s Modulus of Carbon Nanotubes by Micro-Raman Spectroscopy , 1998 .

[19]  Lingping Zhou,et al.  Dry friction and wear characteristics of nickel/carbon nanotube electroless composite deposits , 2006 .

[20]  Gerhard Maier.  The search for low-ε and ultra-low-ε dielectrics: How far can you get with polymers ? Part 1: Background , 2004 .

[21]  Jinping Xiong,et al.  Effects of surfactants on electrodeposition of nickel-carbon nanotubes composite coatings , 2008 .

[22]  G. Maier,et al.  The search for low-/spl epsi/ and ultra-low-/spl epsi/ dielectrics: how far can you get with polymers? Part 1: Background , 2004, IEEE Electrical Insulation Magazine.

[23]  R. Howe,et al.  An integrated CMOS micromechanical resonator high-Q oscillator , 1999, IEEE J. Solid State Circuits.