Performance Analysis of Single-Frequency CW Signal-Based I/Q Regeneration in Five-Port Junction-Based Direct Receivers on Rayleigh Fading Channels

This paper analyzes the influence of the Rayleigh fading channel on the performance of a single-frequency continuous-wave (CW) signal-based I/Q regeneration in five-port junction-based direct receivers. This method uses a single-frequency CW signal to estimate the I/Q regeneration parameters. Simulation results show that the eye diagram, error vector magnitude, and bit error rate performances of five-port junction-based direct receivers using a single-frequency CW signal-based I/Q regeneration are almost the same as those of conventional coherent demodulators, even in fading channels.

[1]  T. Hentschel.  A simple IQ-regeneration technique for six-port communication receivers , 2004, First International Symposium on Control, Communications and Signal Processing, 2004..

[2]  T. Hentschel,et al.  The six-port as a communications receiver , 2005, IEEE Transactions on Microwave Theory and Techniques.

[3]  Heinrich Meyr,et al.  On the error probability of linearly modulated signals on Rayleigh frequency-flat fading channels , 1990, IEEE Trans. Commun..

[4]  Ke Wu,et al.  A six-port direct digital millimeter wave receiver , 1994, Proceedings of IEEE National Telesystems Conference - NTC '94.

[5]  M. W. Oliphant,et al.  An introduction to GSM , 1995 .

[6]  Xinping Huang,et al.  Adaptive I/Q-regeneration in 5-port junction based direct receivers , 1999, Fifth Asia-Pacific Conference on ... and Fourth Optoelectronics and Communications Conference on Communications,.

[7]  F. Laue,et al.  The performance of deterministic Rayleigh fading channel simulators with respect to the bit error probability , 2000, VTC2000-Spring. 2000 IEEE 51st Vehicular Technology Conference Proceedings (Cat. No.00CH37026).

[8]  O. Moreira-Tamayo,et al.  All-digital TX frequency synthesizer and discrete-time receiver for Bluetooth radio in 130-nm CMOS , 2004, IEEE Journal of Solid-State Circuits.

[9]  D. Hindson,et al.  I/Q-channel regeneration in 5-port junction based direct receivers , 1999, 1999 IEEE MTT-S International Topical Symposium on Technologies for Wireless Applications (Cat. No. 99TH8390).

[10]  W. C. Jakes,et al.  Microwave Mobile Communications , 1974 .

[11]  G. Engen.  The Six-Port Reflectometer: An Alternative Network Analyzer , 1977 .

[12]  Hans-Joachim Jentschel,et al.  Compensation of DC-Offsets and RF-Self-Mixing Products in Six-Port-Based Analog Direct Receivers , 2005 .

[13]  J. Wang,et al.  A highly-integrated 3G CDMA2000 1X cellular baseband chip with GSM/AMPS/GPS/Bluetooth/multimedia capabilities and ZIF RIF support , 2004, 2004 IEEE International Solid-State Circuits Conference (IEEE Cat. No.04CH37519).

[14]  Hyung Chul Park,et al.  Unified DC offset cancellation and I/Q regeneration with carrier phase recovery in five-port junction based direct receivers , 2007, 2007 European Microwave Conference.

[15]  G. F. Engen.  Calibrating the Six-Port Reflectometer by Means of Sliding Terminations , 1978 .

[16]  Desmond P. Taylor,et al.  GMSK Modulation for Digital Mobile Radio Telephony , 2007 .

[17]  E. Zeisel,et al.  A highly-integrated tri-band/quad-mode SiGe BiCMOS RF-to-baseband receiver for wireless CDMA/WCDMA/AMPS applications with GPS capability , 2002, 2002 IEEE International Solid-State Circuits Conference. Digest of Technical Papers (Cat. No.02CH37315).

[18]  Hans-Joachim Jentschel,et al.  An effort reduced six-port direct conversion receiver and its calibration , 2005, IEEE Wireless Communications and Networking Conference, 2005.

[19]  Klaus Finkenzeller,et al.  RFID Handbook: Radio-Frequency Identification Fundamentals and Applications , 2000 .