Silicon-Based True-Time-Delay Phased-Array Front-Ends at Ka-Band

A high-power and a low-power fully integrated true-time-delay (TTD) phased-array receiver front-end have been developed for Ka-band applications using a 0.25- μm SiGe:C BiCMOS technology. The high-power front-end, consisting of a high-power low-noise amplifier (LNA) and an active TTD phase shifter, achieves 13.8±1.3 dB gain and a noise figure (NF) below 3.1 dB at 30 GHz. The front-end provides 17.8-ps continuous variable delay, with 3.5% normalized delay variation (NDV) over a 22-37-GHz frequency span. The low-power front-end, composed of a low-power LNA and a passive TTD phase shifter, achieves 14.8±3 dB gain and an NF below 3.2 dB at 30 GHz. The low-power front-end offers 22-ps continuous variable delay with only 5.5% NDV over a 24-40-GHz frequency span. The low-power front-end consumes 22.5-mW power and presents an overall input 1-dB compression point ( P 1 dB) and input third-order intercept point (IIP3) of -22 and -13.8 dBm, respectively. Depending on the linearity requirements, the high-power front-end can operate in dual-power modes. In the high-power (low-power) mode, the measured worst case input P 1 dB and IIP3 are -15.8 ( -18 dBm) and -9 dBm ( -12 dBm) at 30 GHz with an averaged power consumption per channel of 269 mW (111 mW) for similar TTD and gain performance. The core area of the high-power and low-power front-ends are 0.31 and 0.48 mm2, respectively.

[1]  Yihong Chen,et al.  A fully packaged true time delay module for a K-band phased array antenna system demonstration , 2002, IEEE Photonics Technology Letters.

[2]  Ta-Shun Chu,et al.  An Integrated Ultra-Wideband Timed Array Receiver in 0.13 $\mu{\hbox{m}}$ CMOS Using a Path-Sharing True Time Delay Architecture , 2007, IEEE Journal of Solid-State Circuits.

[3]  J. Melai,et al.  BiCMOS technology improvements for microwave application , 2008, 2008 IEEE Bipolar/BiCMOS Circuits and Technology Meeting.

[4]  R. Mahmoudi,et al.  A 30GHz 2dB NF low noise amplifier for Ka-band applications , 2012, 2012 IEEE Radio Frequency Integrated Circuits Symposium.

[5]  Gabriel M. Rebeiz,et al.  Ka-Band SiGe HBT Low Noise Amplifier Design for Simultaneous Noise and Input Power Matching , 2007, IEEE Microwave and Wireless Components Letters.

[6]  R. Mihailovich,et al.  A DC-to-40 GHz four-bit RF MEMS true-time delay network , 2001, IEEE Microwave and Wireless Components Letters.

[7]  Hossein Hashemi,et al.  A true time-delay-based bandpass multi-beam array at mm-waves supporting instantaneously wide bandwidths , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[8]  Eric A. M. Klumperink,et al.  A 1-to-2.5GHz phased-array IC based on gm-RC all-pass time-delay cells , 2012, 2012 IEEE International Solid-State Circuits Conference.

[9]  Bernd Schleicher,et al.  A Tunable Differential All-Pass Filter for UWB True Time Delay and Phase Shift Applications , 2011, IEEE Microwave and Wireless Components Letters.

[10]  J. Roderick,et al.  Silicon-Based Ultra-Wideband Beam-Forming , 2006, IEEE Journal of Solid-State Circuits.

[11]  Sanggu Park,et al.  A 15–40 GHz CMOS True-Time Delay Circuit for UWB Multi-Antenna Systems , 2013, IEEE Microwave and Wireless Components Letters.

[12]  Qian Ma,et al.  A 10–50GHz True-Time-Delay phase shifter with max 3.9% delay variation , 2014, 2014 IEEE Radio Frequency Integrated Circuits Symposium.