Flow regime based calibration of a capacitive void fraction sensor for small diameter tubes

Abstract The void fraction measurement technique used in this work is based on measuring the capacity between two electrodes. The electrodes are curved so they closely fit to the tube wall; due to this the measured capacitance is influenced by the spatial distribution of the phases and not only the void fraction. Hence, the measured capacitance does not linearly vary with the void fraction. In this work a method is proposed to account for the distribution of the phases and thus determine the void fraction based on capacitive measurements. The proposed method was applied to 270 measurement points. The tube diameter D is 8 mm, the mass flux ranges from 200 to 500 kg m −2 s −1 and the vapour fraction ranges between 2.5% and 97.5%. Refrigerants R134a and R410A were used. The results were compared to the Steiner version of the Rouhani–Axelsson drift flux void fraction model. A very good agreement with this model was observed.

[1]  John R. Thome,et al.  Prediction of the entrained liquid fraction in vertical annular gas–liquid two-phase flow , 2010 .

[2]  李东晖,et al.  Gamma-Ray Attenuation Technique For Measuring Void Fraction In Horizontal Gas-Liquid Two-Phase Flow , 2007 .

[3]  Timothy A. Shedd,et al.  Critical friction factor modeling of horizontal annular base film thickness , 2009 .

[4]  Brian E. Williams,et al.  Comparison study of a cluster of four dynamic flow pattern discrimination techniques for multi-phase flow , 1999 .

[5]  Arnout Willockx,et al.  Capacitance signal analysis of horizontal two-phase flow in a small diameter tube , 2008 .

[6]  R. A. Rahim,et al.  Non-invasive imaging of liquid/gas flow using ultrasonic transmission-mode tomography , 2007 .

[7]  A. Ghajar,et al.  Comparison of void fraction correlations for different flow patterns in horizontal and upward inclined pipes , 2007 .

[8]  Wuqiang Yang,et al.  A portable stray-immune capacitance meter , 2002 .

[9]  J. P. Hartnett,et al.  Advances in Heat Transfer , 2003 .

[10]  John R. Thome,et al.  Measurement of dynamic void fractions in stratified types of flow , 2005 .

[11]  Michel De Paepe,et al.  Capacitance Sensor Design For Refrigerant Two‐Phase Flow Characterization , 2007 .

[12]  Vittorio Ferrari,et al.  Capacitance sensor for hold-up measurement in high-viscous-oil/conductive-water core-annular flows , 2011 .

[13]  S. Rouhani,et al.  CALCULATION OF VOID VOLUME FRACTION IN THE SUBCOOLED AND QUALITY BOILING REGIONS , 1970 .

[14]  Michael R. Moldover,et al.  Dielectric Permittivity of Eight Gases Measured with Cross Capacitors , 2003 .

[15]  B. J. Azzopardi,et al.  Measurement of drop sizes , 1979 .

[16]  C. A. Nieto de Castro,et al.  Dielectric properties of liquid refrigerants: Facts and trends , 2011 .

[17]  R.V.A. Oliemans,et al.  Modelling of annular dispersed two-phase flow in vertical pipes , 1986 .

[18]  Keiichi Hori,et al.  Cross-sectional void fraction distribution measurements in a vertical annulus two-phase flow by high speed X-ray computed tomography and real-time neutron radiography techniques , 1999 .

[19]  Clark W. Bullard,et al.  Experimental validation of heat exchanger models for refrigerator/freezers , 1995 .

[20]  Owen C. Jones,et al.  The interrelation between void fraction fluctuations and flow patterns in two-phase flow , 1975 .

[21]  J. Thome,et al.  Investigation of Flow Boiling in Horizontal Tubes: Part II, Development of a New Heat Transfer Model for Stratified-Wavy, Dryout and Mist Flow Regimes , 2005 .

[22]  J. Thome,et al.  Flow Boiling in Horizontal Tubes. Part 1; Development of a Diabatic Two–Phase Flow Pattern Map , 1998 .

[23]  M. Sami A. Abouelwafa,et al.  The Use of Capacitance Sensors for Phase Percentage Determination in Multiphase Pipelines , 1980, IEEE Transactions on Instrumentation and Measurement.

[24]  Barry J. Azzopardi,et al.  High-resolution gas–oil two-phase flow visualization with a capacitance wire-mesh sensor , 2010 .

[25]  J. Thome,et al.  Investigation of Flow Boiling in Horizontal Tubes: Part I, A New Diabatic Two-Phase Flow Pattern Map , 2005 .

[26]  Josua P. Meyer,et al.  Horizontal two-phase flow characterization for small diameter tubes with a capacitance sensor , 2007 .

[27]  Bruno Bauwens,et al.  Mapping of horizontal refrigerant two-phase flow patterns based on clustering of capacitive sensor signals , 2010 .

[28]  Hugo Canière,et al.  Flow pattern mapping of horizontal evaporating refrigerant flow based on capacitive void fraction measurements , 2009 .

[29]  J. Thome,et al.  Flow pattern based two-phase frictional pressure drop model for horizontal tubes, Part II: New phenomenological model , 2007 .

[30]  Barry J. Azzopardi,et al.  Drops in annular two-phase flow , 1997 .

[31]  Hiroshige Kikura,et al.  Tomographic imaging of counter-current bubbly flow by wire mesh tomography , 2007 .

[32]  Refrigerating.  ASHRAE handbook of fundamentals , 1967 .