Micropower Design of a Fully Autonomous Energy Harvesting Circuit for Arrays of Piezoelectric Transducers

This paper presents a self-powered energy harvesting circuit based on synchronous charge extraction with a single shared inductor for power conversion from arrays of independent piezoelectric transducers. The number of handled elements can be easily increased at the expense of few additional components and without affecting performance. The energy harvesting circuit was characterized with three 0.5 × 12.7 × 31.8 mm3 piezoelectric cantilevers subject to different types of vibrations. Throughout all operating conditions, the circuit was able to extract the maximum power independently from every transducer. Compared to passive energy harvesting interfaces, the output power is significantly higher, with worst-case increases ranging from +75% to +184%. The circuit starts up passively and is based on ultralow power active control, which consumes during operation at 3 V a fraction of the extra harvested power as low as 10 μW per source. As part of the best tradeoff between harvested and intrinsic power, an overall energy efficiency up to 74% was achieved.

[1]  Anantha Chandrakasan,et al.  An efficient piezoelectric energy-harvesting interface circuit using a bias-flip rectifier and shared inductor , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[2]  Kartikeya Mayaram,et al.  A Multiple-Input Boost Converter for Low-Power Energy Harvesting , 2011, IEEE Transactions on Circuits and Systems II: Express Briefs.

[3]  Paul D. Mitcheson,et al.  Implementation of a Single Supply Pre-biasing Circuit for Piezoelectric Energy Harvesters , 2012 .

[4]  Di Chen,et al.  A MEMS-based piezoelectric power generator array for vibration energy harvesting , 2008, Microelectron. J..

[5]  Jan M. Rabaey,et al.  A study of low level vibrations as a power source for wireless sensor nodes , 2003, Comput. Commun..

[6]  Wen-Jong Wu,et al.  An improved analysis of the SSHI interface in piezoelectric energy harvesting , 2007 .

[7]  Dong Sam Ha,et al.  Low-Power Design of a Self-powered Piezoelectric Energy Harvesting System With Maximum Power Point Tracking , 2012, IEEE Transactions on Power Electronics.

[8]  R.P. Paganelli,et al.  Dynamic switching conversion for piezoelectric energy harvesting systems , 2008, 2008 IEEE Sensors.

[9]  Paul K. Wright,et al.  A piezoelectric vibration based generator for wireless electronics , 2004 .

[10]  Pedro Lluís Miribel-Català,et al.  A Multiharvested Self-Powered System in a Low-Voltage Low-Power Technology , 2011, IEEE Transactions on Industrial Electronics.

[11]  Marco Ferrari,et al.  Modeling, fabrication and performance measurements of a piezoelectric energy converter for power harvesting in autonomous microsystems , 2006, 2005 IEEE Instrumentationand Measurement Technology Conference Proceedings.

[12]  Sanjib Kumar Panda,et al.  Optimized Wind Energy Harvesting System Using Resistance Emulator and Active Rectifier for Wireless Sensor Nodes , 2011, IEEE Transactions on Power Electronics.

[13]  Luca Benini,et al.  An effective multi-source energy harvester for low power applications , 2011, 2011 Design, Automation & Test in Europe.

[14]  P. D. Mitcheson,et al.  Power-Extraction Circuits for Piezoelectric Energy Harvesters in Miniature and Low-Power Applications , 2012, IEEE Transactions on Power Electronics.

[15]  B. H. Stark,et al.  Review of Power Conditioning for Kinetic Energy Harvesting Systems , 2012, IEEE Transactions on Power Electronics.

[16]  R. Zane,et al.  Custom IC for Ultralow Power RF Energy Scavenging , 2011, IEEE Transactions on Power Electronics.

[17]  Heath Hofmann,et al.  Damping as a result of piezoelectric energy harvesting , 2004 .

[18]  T. Nishida,et al.  System Modeling of Piezoelectric Energy Harvesters , 2012, IEEE Transactions on Power Electronics.

[19]  Yang Sun,et al.  An Integrated High-Performance Active Rectifier for Piezoelectric Vibration Energy Harvesting Systems , 2012, IEEE Transactions on Power Electronics.

[20]  Paul K. Wright,et al.  A STUDY OF AMBIENT VIBRATIONS FOR PIEZOELECTRIC ENERGY CONVERSION , 2009 .

[21]  S. Ben-Yaakov,et al.  Self-Contained Resonant Rectifier for Piezoelectric Sources Under Variable Mechanical Excitation , 2011, IEEE Transactions on Power Electronics.

[22]  Adrien Badel,et al.  A comparison between several vibration-powered piezoelectric generators for standalone systems , 2006 .

[23]  Timothy C. Green,et al.  Energy Harvesting From Human and Machine Motion for Wireless Electronic Devices , 2008, Proceedings of the IEEE.

[24]  Shuo Cheng,et al.  An Active Voltage Doubling AC/DC Converter for Low-Voltage Energy Harvesting Applications , 2011, IEEE Transactions on Power Electronics.

[25]  C. Van Hoof,et al.  Micropower energy harvesting , 2009, ESSDERC 2009.

[26]  Yuan Rao,et al.  An Input-Powered Vibrational Energy Harvesting Interface Circuit With Zero Standby Power , 2011, IEEE Transactions on Power Electronics.

[27]  A. Romani,et al.  Joint Modeling of Piezoelectric Transducers and Power Conversion Circuits for Energy Harvesting Applications , 2013, IEEE Sensors Journal.

[28]  Adrien Badel,et al.  Energy harvesting using piezoelectric materials: Case of random vibrations , 2007 .

[29]  Marco Tartagni,et al.  A scalable micro-power converter for multi-source piezoelectric energy harvesting applications , 2010 .

[30]  Nan-Chyuan Tsai,et al.  Human powered MEMS-based energy harvest devices , 2012 .

[31]  Ivan Stoianov,et al.  INCREASED POWER OUTPUT FROM PIEZOELECTRIC ENERGY HARVESTERS BY PRE-BIASING , 2009 .

[32]  E. Dallago,et al.  Electronic interface for Piezoelectric Energy Scavenging System , 2008, ESSCIRC 2008 - 34th European Solid-State Circuits Conference.

[33]  Marco Ferrari,et al.  Piezoelectric multifrequency energy converter for power harvesting in autonomous microsystems , 2008 .