Characterisation of the signal and noise transfer of CCD cameras for electron detection

Methods to characterise the performance of CCD cameras for electron detection are investigated with particular emphasis on the difference between the transfer of signal and noise. Similar to the Modulation Transfer Function MTF, which describes the spatial frequency dependent attenuation of contrast in the image, we introduce a Noise Transfer Function NTF that describes the transfer of the Poisson noise that is inevitably present in any electron image. A general model for signal and noise transfer by an image converter is provided. This allows the calculation of MTF and NTF from Monte‐Carlo simulations of the trajectories of electrons and photons in the scintillator and the optical coupling of the camera. Furthermore, accurate methods to measure the modulation and noise transfer functions experimentally are presented. The spatial‐frequency dependent Detection Quantum Efficiency DQE, an important figure of merit of the camera which has so far not been measured experimentally, can be obtained from the measured MTF and NTF. The experimental results are in good agreement with the simulations and show that the NTF at high spatial frequencies is in some cases by a factor of four higher than the MTF. This implies that the noise method, which is frequently used to measure the MTF, but in fact measures the NTF, gives over‐optimistic results. Furthermore, the spatial frequency dependent DQE is lower than previously assumed. Microsc. Res. Tech. 49:269–280, 2000. © 2000 Wiley‐Liss, Inc.

[1]  D. Newbury.  Monte Carlo modelling for electron microscopy and microanalysis , 1996 .

[2]  J. Zuo,et al.  Ultramicroscopy Letter Electron detection characteristics of slow-scan CCD camera , 1996 .

[3]  M. Kotera,et al.  Computer simulation of light emission by high-energy electrons in YAG single crystals , 1994 .

[4]  Performance of thin foil scintillating screen for transmission electron microscopy. , 1994, Ultramicroscopy.

[5]  Kazuo Ishizuka,et al.  Optimized sampling schemes for off-axis holography , 1993 .

[6]  Measurement of the modulation transfer function of a slow-scan CCD camera on a TEM using a thin amorphous film as test signal , 1996 .

[7]  Angus I. Kirkland,et al.  The effects of electron and photon scattering on signal and noise transfer properties of scintillators in CCD cameras used for electron detection , 1998 .

[8]  The detection quantum efficiency of electronic image recording systems , 1982 .

[9]  K. Herrmann,et al.  Development and performance of a fast fibre-plate coupled CCD camera at medium energy and image processing system for electron holography , 1996 .

[10]  C. E. SHANNON,et al.  A mathematical theory of communication , 1948, MOCO.

[11]  A Fenster,et al.  A spatial-frequency dependent quantum accounting diagram and detective quantum efficiency model of signal and noise propagation in cascaded imaging systems. , 1994, Medical physics.

[12]  Kenneth H. Downing,et al.  Analysis of photographic emulsions for electron microscopy of two-dimensional crystalline specimens , 1982 .

[13]  M. Rabbani,et al.  Detective quantum efficiency of imaging systems with amplifying and scattering mechanisms. , 1987, Journal of the Optical Society of America. A, Optics and image science.

[14]  P. Mooney,et al.  Applications of slow-scan CCD cameras in transmission electron microscopy , 1993 .

[15]  W. Ruijter,et al.  Methods to measure properties of slow‐scan CCD cameras for electron detection , 1992 .

[16]  D. Krahl,et al.  Performance of a low-noise CCD camera adapted to a transmission electron microscope , 1992 .

[17]  Chris Boothroyd,et al.  Why don't high‐resolution simulations and images match? , 1998 .

[18]  W. Ruijter.  Imaging properties and applications of slow-scan charge-coupled device cameras suitable for electron microscopy , 1995 .

[19]  K. Herrmann,et al.  Performance of electron image converters with YAG single-crystal screen and CCD sensor , 1991 .

[20]  I A Cunningham,et al.  Signal and noise in modulation transfer function determinations using the slit, wire, and edge techniques. , 1992, Medical physics.