We developed a new finishing method using an advanced ECM (electrochemical machining) assisted by fine abrasive grains in order to finish surfaces of 3-dimensional micro components used in MEMS. With the method, a fine surface of selected micro-area, which is not obtained by micro-EDM (electrodischarge machining) nor conventional ECM, is created in a few minutes. We also developed an advanced machine which has a performance to make 3-D complicated micro structures with fine surfaces by the combination of the micro-EDM and the developed finishing method. The performance is achieved by a sequential process without workpiece handling from the micro-EDM to the finishing. Using the new machine, we obtained a high precision shaft with a mirror-like surface. The result is satisfactory to apply the method to make a cylindrical substrate for a rotor of micro wobble motor. We are sure that the process will be applied to producing practical micro mechanical components.
[1]
T. Masuzawa,et al.
Micro electro-discharge machining and its applications
,
1990,
IEEE Proceedings on Micro Electro Mechanical Systems, An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots..
[2]
W. Menz,et al.
The LIGA technique-A novel concept for microstructures and the combination with Si-technologies by injection molding
,
1991,
[1991] Proceedings. IEEE Micro Electro Mechanical Systems.
[3]
A concentric build-up process to fabricate practical wobble motors
,
1994,
Proceedings IEEE Micro Electro Mechanical Systems An Investigation of Micro Structures, Sensors, Actuators, Machines and Robotic Systems.