The work deals with the fundamentals of nanomodification of the GS3 heat-resisting multicomponent nickel alloy, out of which blades for gas turbine engines are made. The selection of the modifier for the experimental alloy was justified; the technology of acquiring the nanomodifier, using the plasma-chemical synthesis method, was
developed; and the calculations of the specific surface of the TiC particles were performed. The required quantity of nanomodifier introduced to the liquid alloy to acquire the set structure was determined experimentally. Through electronic microprobe analysis, introduction to the metal matric of nanoparticles of titanium carbide is approved.
Nanomodification allows achieving refinement of the GS3 nickel alloy structure, which is going to provide an opportunity to increase the effective life of gas turbine engine blades.
[1]
Influence of structure and phase composition on wear resistance of sparingly alloyed alloys
,
2023,
Functional Materials.
[2]
V. S. Vahrusheva,et al.
INCREASING THE CORROSION RESISTANCE OF HEAT-RESISTANT ALLOYS FOR PARTS OF POWER EQUIPMENT
,
2022,
Problems of Atomic Science and Technology.
[3]
V. Volchuk,et al.
Structure and properties of powder gas-plasma coatings based on nickel
,
2022,
Bulletin of Kharkov National Automobile and Highway University.
[4]
Influence of nanomodification on structure formation of multicomponent nickel alloys
,
2019,
Functional Materials.
[5]
Jong-Hyeon Lee,et al.
Self-propagating high-temperature synthesis of nano-sized titanium carbide powder
,
2002
.