Remarkable Wear Resistance in a Complex Concentrated Alloy with Nanohierarchical Architecture and Composition Undulation

Sustained wear damages on the sliding surfaces of alloys are generally the culprit responsible for the failure of various mechanical systems. Inspired by high-entropy effects, here we deliberately deploy nanohierarchical architecture with composition undulation in a Ni50(AlNbTiV)50 complex concentrated alloy, which yields ultralow wear rate within the order of 10−7 to 10−6 mm3/Nm between room temperature and 800 °C. Such remarkable wear resistance heretofore represents one of the highest wear resistance reported for the bulk alloys or composites, and originates from the multi-type adaptive friction interface protection governed by intrinsically nano-coupled grains and nanoprecipitates. This cooperative heterostructure releases gradient frictional stress in stages upon wear at room temperature through the coexistence of multiple deformation pathways while activating a dense nanocrystalline glaze layer upon wear at 800 °C to minimize adhesive and oxidative wear. Our work uncovers a practical avenue for tailoring wear properties with multicomponent heterostructures over a wide temperature range.

[1]  P. Choi,et al.  Doubled strength and ductility via maraging effect and dynamic precipitate transformation in ultrastrong medium-entropy alloy , 2023, Nature Communications.

[2]  Changfeng Chen,et al.  Solving Strength–Toughness Dilemma in Superhard Transition-Metal Diborides via a Distinct Chemically Tuned Solid Solution Approach , 2023, Research.

[3]  M. Heilmaier,et al.  Temporal sequence of deformation twinning in CoCrNi under tribological load , 2022, Scripta Materialia.

[4]  Wanting Sun,et al.  Superior wear resistance in a TaMoNb compositionally complex alloy film via in-situ formation of the amorphous-crystalline nanocomposite layer and gradient nanostructure , 2022, Acta Materialia.

[5]  H. Fraser,et al.  Ultrastrong nanotwinned titanium alloys through additive manufacturing , 2022, Nature Materials.

[6]  Zhichao Ma,et al.  Graphene Oxide-Induced Substantial Strengthening of High-Entropy Alloy Revealed by Micropillar Compression and Molecular Dynamics Simulation , 2022, Research.

[7]  Zhongwu Zhang,et al.  Transition of plastic deformation mechanisms governed by spacing of nano-precipitates in a high entropy alloy , 2022, Scripta Materialia.

[8]  Jun Sun,et al.  Surface-Condition-Dependent Deformation Mechanisms in Lead Nanocrystals , 2022, Research.

[9]  D. Ponge,et al.  High stress twinning in a compositionally complex steel of very high stacking fault energy , 2022, Nature Communications.

[10]  G. Sha,et al.  Uniting tensile ductility with ultrahigh strength via composition undulation , 2022, Nature.

[11]  W. Wei,et al.  A new strong pearlitic multi-principal element alloy to withstand wear at elevated temperatures , 2022, Acta Materialia.

[12]  Hao-wei Wang,et al.  Achieving the lightweight wear-resistant TiC reinforced AlFeCrCo medium-entropy alloy coating on Mg alloy via resistance seam processing , 2022, Scripta Materialia.

[13]  Wei-min Liu,et al.  Tuning the mechanical and high temperature tribological properties of Co-Cr-Ni medium-entropy alloys via controlling compositional heterogeneity , 2021 .

[14]  K. An,et al.  Gradient cell–structured high-entropy alloy with exceptional strength and ductility , 2021, Science.

[15]  M. Herbig,et al.  Reactive wear protection through strong and deformable oxide nanocomposite surfaces , 2021, Nature Communications.

[16]  C. Greiner,et al.  Tribologically induced crystal rotation kinematics revealed by electron backscatter diffraction , 2021, Acta Materialia.

[17]  F. Ren,et al.  Achieving low wear in a μ-phase reinforced high-entropy alloy and associated subsurface microstructure evolution , 2021 .

[18]  Z. Jiao,et al.  Synergistic effects of Al and Ti on the oxidation behaviour and mechanical properties of L12-strengthened FeCoCrNi high-entropy alloys , 2021 .

[19]  Shengyu Zhu,et al.  Tribological performances of CoCrFeNiAl high entropy alloy matrix solid-lubricating composites over a wide temperature range , 2021, Tribology International.

[20]  Hao Wu,et al.  Strengthening FeCrNiCu high entropy alloys via combining V additions with in-situ TiC particles , 2021 .

[21]  I. Szlufarska,et al.  Wear-induced microstructural evolution of ultra-fine grained (UFGs) aluminum , 2021 .

[22]  Tao Yang,et al.  Ultrahigh strength and ductility in newly developed materials with coherent nanolamellar architectures , 2020, Nature Communications.

[23]  S. Mukherjee,et al.  High temperature wear behavior of refractory high entropy alloys based on 4-5-6 elemental palette , 2020 .

[24]  Bin Yang,et al.  Multistage work hardening assisted by multi-type twinning in ultrafine-grained heterostructural eutectic high-entropy alloys , 2020 .

[25]  F. Ren,et al.  Significant reduction in friction and wear of a high-entropy alloy via the formation of self-organized nanolayered structure , 2020 .

[26]  Wei-min Liu,et al.  Vacuum tribological behaviors of CoCrFeNi high entropy alloy at elevated temperatures , 2020 .

[27]  Shijian Zheng,et al.  High-strength and high-ductility AlCoCrFeNi2.1 eutectic high-entropy alloy achieved via precipitation strengthening in a heterogeneous structure , 2020 .

[28]  X. J. Liu,et al.  Ultrahigh-strength and ductile superlattice alloys with nanoscale disordered interfaces , 2020, Science.

[29]  Jian Lu,et al.  Crystal–Glass High‐Entropy Nanocomposites with Near Theoretical Compressive Strength and Large Deformability , 2020, Advanced materials.

[30]  F. Akhtar,et al.  High temperature tribology and wear of selective laser melted (SLM) 316L stainless steel , 2020 .

[31]  R. Ritchie,et al.  Short-range order and its impact on the CrCoNi medium-entropy alloy , 2019, Nature.

[32]  Z. Jiao,et al.  Achieving exceptional wear resistance in a compositionally complex alloy via tuning the interfacial structure and chemistry , 2020 .

[33]  Hui‐Shen Shen,et al.  Temperature-Dependent Mechanical Properties of Graphene/Cu Nanocomposites with In-Plane Negative Poisson's Ratios , 2020, Research.

[34]  Ruirun Chen,et al.  Effects of Tantalum on Microstructure Evolution and Mechanical Properties of High-Nb TiAl Alloys Reinforced by Ti2AlC , 2019, Research.

[35]  Y. Zhuang,et al.  The role of Nb on the high temperature oxidation behavior of CoCrFeMnNbxNi high-entropy alloys , 2019, Corrosion Science.

[36]  C. Suryanarayana.  Mechanical Alloying: A Novel Technique to Synthesize Advanced Materials , 2019, Research.

[37]  C. Tasan,et al.  Engineering atomic-level complexity in high-entropy and complex concentrated alloys , 2019, Nature Communications.

[38]  Shengyu Zhu,et al.  High temperature solid-lubricating materials: A review , 2019, Tribology International.

[39]  Xiao-hui Shi,et al.  The tribological properties of Al0.6CoCrFeNi high-entropy alloy with the σ phase precipitation at elevated temperature , 2019, Journal of Alloys and Compounds.

[40]  Wei Li,et al.  Formation of a self-lubricating layer by oxidation and solid-state amorphization of nano-lamellar microstructures during dry sliding wear tests , 2019, Acta Materialia.

[41]  P. Liaw,et al.  Effects of temperature on the tribological behavior of Al0.25CoCrFeNi high-entropy alloy , 2019, Journal of Materials Science & Technology.

[42]  D. Ponge,et al.  Ultrastrong Medium‐Entropy Single‐Phase Alloys Designed via Severe Lattice Distortion , 2018, Advanced materials.

[43]  C. Greiner,et al.  Microstructure evolution and deformation mechanisms during high rate and cryogenic sliding of copper , 2018, Acta Materialia.

[44]  E. Lavernia,et al.  Engineering heterostructured grains to enhance strength in a single-phase high-entropy alloy with maintained ductility , 2018, Materials Research Letters.

[45]  Xiang Chen,et al.  Friction and Wear Reduction in Copper with a Gradient Nano-grained Surface Layer. , 2018, ACS applied materials & interfaces.

[46]  Liang Wang,et al.  Composition design of high entropy alloys using the valence electron concentration to balance strength and ductility , 2018 .

[47]  Q. Xue,et al.  Continuously Growing Ultrathick CrN Coating to Achieve High Load-Bearing Capacity and Good Tribological Property. , 2018, ACS applied materials & interfaces.

[48]  Jiesheng Han,et al.  Microstructure, mechanical properties and tribological performance of CoCrFeNi high entropy alloy matrix self-lubricating composite , 2017 .

[49]  Xiang Chen,et al.  Lowering coefficient of friction in Cu alloys with stable gradient nanostructures , 2016, Science Advances.

[50]  Lingqian Kong,et al.  NiAl Matrix Self-Lubricating Composite at a Wide Temperature Range , 2015 .

[51]  Wenzheng Zhai,et al.  Tribological behavior of Ni3Al matrix self-lubricating composites containing WS2, Ag and hBN tested from room temperature to 800°C , 2014 .

[52]  Wenzheng Zhai,et al.  Tribological behaviors of NiAl based self-lubricating composites containing different solid lubricants at elevated temperatures , 2014 .

[53]  Bin Wang,et al.  High temperature tribological behaviors of plasma electrolytic borocarburized Q235 low-carbon steel , 2013 .

[54]  Wei-min Liu,et al.  Tribological behavior of NiAl matrix composites with addition of oxides at high temperatures , 2012 .

[55]  Wei-min Liu,et al.  Influence of Cr content on tribological properties of Ni3Al matrix high temperature self-lubricating composites , 2011 .

[56]  W. M. Rainforth,et al.  Wear and friction of TiAlN/VN coatings against Al2O3 in air at room and elevated temperatures , 2010 .

[57]  I. Gunes,et al.  High temperature wear and friction properties of duplex surface treated bearing steels , 2008 .

[58]  Y. Yamamoto,et al.  Creep-Resistant, Al2O3-Forming Austenitic Stainless Steels , 2007, Science.

[59]  J. Bogdanoff,et al.  On the Theory of Dislocations , 1950 .

[60]  C. Cheung,et al.  bcc → hcp phase transition significantly enhancing the wear resistance of metastable refractory high-entropy alloy , 2022, Scripta Materialia.

[61]  Shengyu Zhu,et al.  Tribological behavior of Ni3Al–Ag based self-lubricating alloy with Ag2MoO4 formed by high temperature tribo-chemical reaction , 2021 .

[62]  Cheng Lu,et al.  High temperature tribological behaviors and wear mechanisms of NiAl–NbC–Ag composites formed by in-situ decomposition of AgNbO3 , 2020, Tribology International.

[63]  H. Nagai,et al.  Deleterious Effect of Ti Addition on the Oxidation Resistance of Ni–20Cr Alloy , 1981 .