Kinematic Characteristics of 3-UPU Parallel Manipulator in Singularity and Its Application

Abstract This paper focuses on the kinematic characteristics of the 3-UPU (universal-prismatic-universal) parallel manipulator in one of singular configurations. The motion of the moving platform is analyzed by changing the layout of the universal joints. A layout of universal joints in the singular configuration is discussed in detail by deriving the kinematic and constraint equations. Solving the equations, the kinematic characteristics in such case is obtained. At the same time the kinematic characteristics is simulated by the commercial software and the results of the simulation verify it. Based on the kinematics characteristics of it, the application of the singular configuration is presented. And a compound limb which can translate freely along a circular path is presented. Finally, the some new 2-DOF (degree of freedom) planar parallel translating manipulators whose orientation can remain constant are put forward by the compound limb. The passive joints of the new 2-DOF planar parallel translating manipulators are universal joint and the struts of it do not bear the bending moment. It gives the planar parallel manipulator a good architecture to resist the force which is perpendicular to the kinematics plane.

[1]  Ron P. Podhorodeski,et al.  Singularity analysis of planar parallel manipulators based on forward kinematic solutions , 2009 .

[2]  Clément Gosselin,et al.  Singularity analysis of closed-loop kinematic chains , 1990, IEEE Trans. Robotics Autom..

[3]  Jean-Pierre Merlet,et al.  Singular Configurations of Parallel Manipulators and Grassmann Geometry , 1988, Int. J. Robotics Res..

[4]  R. G. Fenton,et al.  A Unifying Framework for Classification and Interpretation of Mechanism Singularities , 1995 .

[5]  Clément Gosselin,et al.  Constraint singularities of parallel mechanisms , 2002, Proceedings 2002 IEEE International Conference on Robotics and Automation (Cat. No.02CH37292).

[7]  K. H. Hunt,et al.  Structural Kinematics of In-Parallel-Actuated Robot-Arms , 1983 .

[8]  Jean-Pierre Merlet.  Singular Configurations of Parallel Manipulators and Grassmann Geometry , 1989, Int. J. Robotics Res..

[9]  Atsushi Konno,et al.  Analytic singularity analysis of a 4-DOF parallel robot based on Jacobian deficiencies , 2010 .

[10]  F. Park,et al.  Kinematic sensitivity analysis of the 3-UPU parallel mechanism , 2002 .

[11]  L. Tsai,et al.  Kinematics and Optimization of a Spatial 3-UPU Parallel Manipulator , 2000 .

[12]  Damien Chablat,et al.  Singularity Analysis of Lower Mobility Parallel Manipulators Using Grassmann–Cayley Algebra , 2009, IEEE Transactions on Robotics.

[13]  Lung-Wen Tsai,et al.  Kinematics of A Three-Dof Platform with Three Extensible Limbs , 1996 .

[14]  Ashitava Ghosal,et al.  Singularity Analysis of Platform-type Multi-loop Spatial Mechanisms , 1997 .

[15]  Ming Z. Huang,et al.  A study of workspace and singularity characteristics for design of 3-DOF planar parallel robots , 2010 .

[16]  Zouhaier Affi,et al.  Prediction of the pose errors produced by joints clearance for a 3-UPU parallel robot , 2009 .