Digital Control of Resonant Converters: Enhancing Frequency Resolution by Dithering

Resonant converters and related systems, such as piezoelectric transformers, may require a high-resolution frequency drive when the quality factor of the network is high or to avoid limit cycle oscillations. This high frequency resolution requirement could be beyond the capabilities of low cost microcontrollers. To remedy this problem, a frequency resolution enhancement algorithm was developed, tested by simulations and verified experimentally. The proposed approach is based on a modification of the fractional-N dithering concept and includes an adaptive dithering period and smooth DPWM frequency transitions. The implementation of the approach on the digital hardware is simple and requires modest additional workload from the CPU. Theoretical analysis was carried out to model the proposed dithering method when applied to drive resonant network in order to identify the causes and to quantify the expected output signal distortion when the signal is used to drive resonant networks. The proposed approach was tested experimentally on two types of resonant converters: a series-resonant parallel-loaded converter and a piezoelectric transformer. It was found that the output signal distortion is less than 1% of the peak amplitude of the output drive which would be acceptable in many applications. The experimental results were found to be in excellent agreement with the theoretical predictions, validating the usefulness of the dithering method as a frequency resolution enhancer for resonant network drive.

[1]  T. Riley,et al.  Delta-sigma modulation in fractional-N frequency synthesis , 1993 .

[2]  Regan Zane,et al.  Digital Control of a Low-Frequency Square-Wave Electronic Ballast With Resonant Ignition , 2008, IEEE Transactions on Industrial Electronics.

[3]  G. Ivensky,et al.  Analysis and modeling of a voltage doubler rectifier fed by a piezoelectric transformer , 2004, IEEE Transactions on Power Electronics.

[4]  Kyu Min Cho,et al.  A digital controlled electronic ballast using high frequency modulation method for the metal halide lamp , 2002, 2002 IEEE 33rd Annual IEEE Power Electronics Specialists Conference. Proceedings (Cat. No.02CH37289).

[5]  R.-L. Lin,et al.  Electronic ballast for fluorescent lamps with phase-locked loop control scheme , 2006, IEEE Transactions on Power Electronics.

[6]  Mor Mordechai Peretz,et al.  Digital Control of Resonant Converters: Frequency Limit Cycles Conditions , 2009, 2009 Twenty-Fourth Annual IEEE Applied Power Electronics Conference and Exposition.

[7]  In-Hwan Oh,et al.  A full-digital dimming ballast with a digital power controller (DPC) for a fluorescent lamp , 2004, Conference Record of the 2004 IEEE Industry Applications Conference, 2004. 39th IAS Annual Meeting..

[8]  B. Miller,et al.  A multiple modulator fractional divider , 1991 .

[9]  B. Miller,et al.  A multiple modulator fractional divider , 1990, 44th Annual Symposium on Frequency Control.

[10]  N. S. Bayindir,et al.  DSP-based PLL-controlled 50-100 kHz 20 kW high-frequency induction heating system for surface hardening and welding applications , 2003 .

[11]  R. Zane,et al.  Fully integrated ballast controller with digital phase control , 2005, Twentieth Annual IEEE Applied Power Electronics Conference and Exposition, 2005. APEC 2005..

[12]  A.J. Calleja,et al.  Development of a high-voltage closed-loop power supply for ozone generation , 2008, 2008 Twenty-Third Annual IEEE Applied Power Electronics Conference and Exposition.

[13]  M. Høvin,et al.  Delta-sigma modulators using frequency-modulated intermediate values , 1997, IEEE J. Solid State Circuits.