Effect of coarse aggregate size and matrix quality on ITZ and failure behavior of concrete under uniaxial compression

Effects of coarse aggregate size and water/cement (w/c) ratio of the matrix on the formation of interfacial transition zone (ITZ) and subsequently on the failure process of concrete under uniaxial compression were studied. For this purpose, a series of experiments were designed and carried out on mortars with two different w/c ratios containing single spherical steel aggregates of different sizes. The ITZ properties and the failure process of concrete were investigated through tensile strength tests both before and after compressive preloading, stress-axial strain, stress-volumetric strain and stress-lateral strain measurements. It was observed that ITZ becomes critical for larger aggregates and lower w/c ratio mortar matrices. The negative effect of smooth surface texture of the aggregate and the large difference between aggregate and matrix moduli of elasticity on the properties of ITZ is of paramount importance for low w/c ratio composites. The effect of reduced bond properties of ITZ relative to its matrix was reflected in the lower critical stress levels for the low w/c ratio composites with larger aggregates. (A) "Reprinted with permission from Elsevier".

[1]  F. P. Glasser,et al.  Formation of spurrite, Ca5(SiO4)2CO3 , 1990 .

[2]  T. Sasaki,et al.  FAILURE PROCESS OF CONCRETE: CRACK INITIATION AND PROPAGATION , 1980 .

[3]  J. Mier.  Fracture Processes of Concrete , 1997 .

[4]  K. Scrivener,et al.  The percolation of pore space in the cement paste/aggregate interfacial zone of concrete , 1996 .

[5]  Surendra P. Shah,et al.  CRITICAL STRESS, VOLUME CHANGE, AND MICROCRACKING OF CONCRETE , 1968 .

[6]  P. Aitcin,et al.  Effect of Coarse Aggregate Characteristics on Mechanical Properties of High-Strength Concrete , 1990 .

[7]  F. Slate,et al.  Microcracking of Plain Concrete and the Shape of the Stress-Strain Curve , 1963 .

[8]  C. Boulay,et al.  On the importance of initial stresses in concrete and of the resulting mechanical effects , 1987 .

[9]  G. Prokopski,et al.  Interfacial transition zone in cementitious materials , 2000 .

[10]  J. E. Gillott,et al.  The influence of mortar-aggregate bond strength on the behaviour of concrete in uniaxial compression , 1977 .

[11]  Surendra P. Shah,et al.  Internal Cracking and Strain Softening Response of Concrete Under Uniaxial Compression , 1987 .

[12]  R. Zimbelmann,et al.  A contribution to the problem of cement-aggregate bond , 1985 .

[13]  G. Prokopski,et al.  Effect of water/cement ratio and silica fume addition on the fracture toughness and morphology of fractured surfaces of gravel concretes , 2000 .

[14]  A. Delibes Liners,et al.  Microcracking of concrete under compression and its influence on tensile strength , 1987 .

[15]  Turan Özturan,et al.  Effect of coarse aggregate type on mechanical properties of concretes with different strengths , 1997 .

[16]  Arnon Bentur,et al.  Autogenous shrinkage and induced restraining stresses in high-strength concretes , 2000 .

[17]  W. F. Chen,et al.  Effect of transition zone on elastic moduli of concrete materials , 1996 .

[18]  P. Monteiro,et al.  The aggregate-mortar interface , 1985 .

[19]  Shuaib H. Ahmad,et al.  Effect of transition zone on the elastic behavior of cement-based composites , 1995 .

[20]  Mehmet Ali Tasdemir,et al.  Evaluation of strains at peak stresses in concrete: A three-phase composite model approach , 1998 .

[21]  F. D. Lydon,et al.  Effect of coarse aggregate on elastic modulus and compressive strength of high performance concrete , 1995 .

[22]  John C. Cripps,et al.  Aggregate-cement paste interface: Part I. Influence of aggregate geochemistry , 1999 .