论文信息 - Reduction of power converter EMI emission using soft-switching technique

Reduction of power converter EMI emission using soft-switching technique

Measurements of conducted and radiated electromagnetic interference (EMI) emission from hard-switched and soft-switched buck, boost, and flyback converters of similar power ratings are presented. Results indicate that EMI emission can be substantially reduced by using a soft-switching technique in power converters. Thus, the soft-switching technique provides a practical and useful solution to reduce EMI emission from switched-mode power circuits. A comparison of EMI emission on the three classes of converters is also included. The flyback converter is found to be the least EMC friendly among the converters tested.

Henry Shu-Hung Chung | Shu Yuen Ron Hui | K. K. Tse | H. Chung | S. Hui

[1] E. H. Newman,et al. Remote detection of a thin slit in a thick ground plane , 1987 .

[2] Ivo Barbi,et al. Buck quasi-resonant converter operating at constant frequency: analysis, design and experimentation , 1989 .

[3] K.W.E. Cheng,et al. A fully soft-switched extended-period quasi-resonant power-factor-correction circuit , 1997 .

[4] Fred C. Lee,et al. Novel zero-current-transition PWM converters , 1993 .

[5] C. Christopoulos. Electromagnetic compatibility. II. Design principles , 1992 .

[6] Roger F. Harrington,et al. Electromagnetic transmission through narrow slots in thick conducting screens , 1980 .

[7] Henry W. Ott,et al. Noise Reduction Techniques in Electronic Systems , 1976 .

[8] Rui Liu,et al. Comparison of EMI performance of PWM and resonant power converters , 1993, Proceedings of IEEE Power Electronics Specialist Conference - PESC '93.

[9] George C. Verghese,et al. Principles of Power Electronics , 2023 .

[10] T. Senior,et al. Electromagnetic and Acoustic Scattering by Simple Shapes , 1969 .

[11] Nathan Marcuvitz. Waveguide Handbook , 1951 .

[12] C. Christopoulos. Electromagnetic compatibility. I. General principles , 1992 .