Mastering Cryogenic Propellants

AbstractThe National Aeronautics and Space Administration (NASA) Glenn Research Center (GRC) began experimentation with cryogenic propellants in the early 1950s to understand the potential of these high-performance propellants for use in liquid propellant rocket engines. Supporting these tests required learning how to both design cryogenic systems and develop procedures to safely and reliably work with cryogenic fuels and oxidizers. This early work led to the development of a skill set that has been core to the center ever since. When NASA was formed and the exploration missions were defined, it became clear that the ability to use cryogenic propellants in the thermal and microgravity environment of space was critical to mission success, and the agency was tasked with enabling this capability. To support development of the Centaur upper stage and the Saturn S-IVB stage, GRC researchers and engineers initiated extensive technology development for the in-space application of cryogenic fluid management (CFM)...

[1]  CFD simulation of Pressure Drops in Liquid Acquisition Device Channel with Sub-Cooled Oxygen , 2009 .

[2]  Thomas J. VanOverbeke.  Thermodynamic Vent System Test in a Low Earth Orbit Simulation , 2004 .

[3]  Mohammad Kassemi,et al.  Numerical and experimental comparisons of the self-pressurization behavior of an LH2 tank in normal gravity , 2008 .

[4]  David W. Plachta,et al.  Demonstration of a Cryogenic Boil-Off Reduction System Employing an Actively Cooled Thermal Radiation Shield , 2008 .

[5]  David J. Chato,et al.  Screen Channel Liquid Acquisition Devices for Cryogenic Propellants , 2002 .

[7]  Yongkang Chen,et al.  Introducing SE-FIT: Surface Evolver - Fluid Interface Tool for Studying Capillary Surfaces , 2011 .

[8]  J. A. Stark,et al.  Zero-g Hydrogen Tank Venting Systems , 1967 .

[9]  R. Lacovic.  Propellant management report for the Titan Centaur TC-5 extended mission , 1977 .

[10]  John I. Hochstein,et al.  Modeling of impulsive propellant reorientation , 1991 .

[11]  I. E. Sumner.  Liquid propellant reorientation in a low-gravity environment , 1978 .

[12]  John M. Jurns,et al.  Liquid oxygen liquid acquisition device bubble point tests with high pressure lox at elevated temperatures , 2012 .

[13]  Monica C. Guzik,et al.  AN ACTIVE BROAD AREA COOLING MODEL OF A CRYOGENIC PROPELLANT TANK WITH A SINGLE STAGE REVERSE TURBO- BRAYTON CYCLE CRYOCOOLER , 2011 .

[14]  L. J. Hastings,et al.  Spray Bar Zero-Gravity Vent System for On-Orbit Liquid Hydrogen Storage , 2003 .

[15]  R. F. Lacovic.  Centaur zero gravity coast and engine restart demonstration on the Titan/Centaur (TC-2) extended mission , 1975 .

[16]  Maureen T. Kudlac,et al.  Screen Channel Liquid Acquisition Devices for Liquid Oxygen , 2006 .

[17]  E. W. Otto.  Static and dynamic behavior of the liquid- vapor interface during weightlessness , 1966 .

[18]  Jeffrey Follo,et al.  Propellant Quantity Gauging Using the Radio Frequency Mass Gauge , 2011 .

[19]  David J. Chato.  Ground testing of the nonvented fill method of orbital propellant transfer - Results of initial test series , 1991 .

[20]  Richard H. Knoll,et al.  Development and test of the Shuttle/Centaur cryogenic tankage thermal protection system , 1987 .

[21]  John I. Hochstein,et al.  Numerical modeling of on-orbit propellant motion resulting from an impulsive acceleration , 1987 .

[22]  David W. Plachta,et al.  CRYOGENIC PROPELLANT BOIL-OFF REDUCTION SYSTEM , 2008 .

[23]  Jeffrey G. Marchetta,et al.  Three Dimensional Modeling of Jet-Induced Geysers in Low Gravity , 2007 .

[24]  L. J. Hastings,et al.  Testing the Effects of Helium Pressurant on Thermodynamic Vent System Performance with Liquid Hydrogen , 2008 .

[25]  D. Chato,et al.  Liquid Motion Experiment Flight Test Results , 1998 .

[26]  Matthew E. Moran,et al.  Hydrogen no-vent fill testing in a 1.2 cubic foot (34 liter) tank , 1991 .

[27]  J. C. Aydelott,et al.  Computational modeling of jet induced mixing of cryogenic propellants in low-G , 1984 .

[28]  Richard H. Knoll,et al.  A review of candidate multilayer insulation systems for potential use on wet-launched LH2 tankage for the space exploration initiative lunar missions , 1991 .

[29]  D. M. Defelice.  TARGET/CRYOCHIL - THERMODYNAMIC ANALYSIS AND SUBSCALE MODELING OF SPACE-BASED ORBIT TRANSFER VEHICLE CRYOGENIC PROPELLANT RESUPPLY , 1987 .

[30]  J. L. Kramer,et al.  An analytical study of reduced-gravity flow dynamics , 1976 .

[31]  William J. Taylor,et al.  Improved thermodynamic modelling of the no-vent fill process and correlation with experimental data , 1991 .

[32]  N. T. Vandresar.  Liquid Oxygen Thermodynamic Vent System Testing with Helium Pressurization , 2014 .

[33]  J. C. Aydelott.  Normal gravity self-pressurization of 9-inch- /23 cm/ diameter spherical liquid hydrogen tankage , 1967 .

[34]  Franklin T. Dodge,et al.  Propellant Mass Gauging: Database of Vehicle Applications and Research and Development Studies , 2008 .

[35]  David Plachta.  Results of an Advanced Development Zero Boil-Off Cryogenic Propellant Storage Test , 2004 .

[36]  Olga Kartuzova,et al.  Modeling Interfacial Turbulent Heat Transfer during Ventless Pressurization of a Large Scale Cryogenic Storage Tank in Microgravity , 2011 .

[37]  F. C. Yeh,et al.  Management of cryogenic propellants in a full scale orbiting space vehicle , 1968 .

[38]  Richard H. Knoll,et al.  TANK PRESSURE CONTROL EXPERIMENT: RESULTS OF THREE SPACE FLIGHTS , 1997 .

[39]  Virginia P. Dawson,et al.  Taming Liquid Hydrogen: The Centaur Upper Stage Rocket , 2004 .

[40]  Mohammad M. Hasan,et al.  Self-pressurization of a flightweight liquid hydrogen tank - Effects of fill level at low wall heat flux , 1992 .

[41]  David J. Chato,et al.  Vented Tank Resupply Experiment - Flight test results , 1997 .