Design, fabrication and performance evaluation of a compact regenerative evaporative cooler: Towards low energy cooling for buildings

Abstract The urges of reducing energy use and carbon footprint in buildings have prompted the developments of regenerative evaporative coolers (RECs). However, the physical dimensions of RECs have to be designed enormous in order to deliver a large amount of supply airflow rate and cooling capacity. To tackle the issue, this paper develops a large-scale counter-flow REC with compact heat exchanger through dedicated numerical modelling, optimal design, fabrication and experimentation. Using modified e-NTU method, a finite element model is established in Engineering Equation Solver environment to optimise the cooler's geometric and operating parameters. Based on modelling predictions, the cooler's experimental prototype was optimally designed and constructed to evaluate operating performance. The experiment results show that the cooler's attained wet-bulb effectiveness ranges from 0.96 to 1.07, the cooling capacity and energy efficiency ratio from 3.9 to 8.5 kW and 10.6 to 19.7 respectively. It can provide sub-wet bulb cooling while operating at high intake channel air velocities of 3.04–3.60 m/s. The superior performance of proposed cooler is disclosed by comparing with different RECs under similar operating conditions. Both the cooler's cooling capacity per unit of volume and per unit of airflow rate are found to be 62–108% and 21.6% higher respectively.

[1]  Frank Bruno,et al.  On-site experimental testing of a novel dew point evaporative cooler , 2011 .

[2]  Xudong Zhao,et al.  Experimental study of a counter-flow regenerative evaporative cooler , 2016 .

[3]  S. Riffat,et al.  Numerical study of a novel counter-flow heat and mass exchanger for dew point evaporative cooling. , 2008 .

[4]  Deying Li,et al.  Numerical investigation of the energy performance of a guideless irregular heat and mass exchanger with corrugated heat transfer surface for dew point cooling , 2016 .

[5]  Ghassem Heidarinejad,et al.  Novel modeling of an indirect evaporative cooling system with cross-flow configuration , 2015 .

[6]  Leland E. Gillan,et al.  EVALUATING COOLERADO CORPORTION'S HEAT-MASS EXCHANGER PERFORMANCE THROUGH EXPERIMENTAL ANALYSIS , 2011 .

[7]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[8]  Ala Hasan.  Going below the wet-bulb temperature by indirect evaporative cooling: Analysis using a modified ε-NTU method , 2012 .

[9]  Dae-Young Lee,et al.  Experimental study of a counter flow regenerative evaporative cooler with finned channels , 2013 .

[10]  Ala Hasan,et al.  Indirect evaporative cooling : Past, present and future potentials , 2012 .

[11]  Sergey Anisimov,et al.  Theoretical study of the basic cycles for indirect evaporative air cooling , 2015 .

[12]  R. Shah,et al.  Handbook of single-phase convective heat transfer , 1987 .

[13]  P. J. Banks,et al.  A General Theory of Wet Surface Heat Exchangers and its Application to Regenerative Evaporative Cooling , 1981 .

[14]  Sergey Anisimov,et al.  Performance investigation of a M (Maisotsenko)-cycle cross-flow heat exchanger used for indirect evaporative cooling , 2014 .

[15]  William M. Worek,et al.  Optimization of wet-surface heat exchangers , 1989 .

[16]  Changhong Zhan,et al.  Comparative study of the performance of the M-cycle counter-flow and cross-flow heat exchangers for indirect evaporative cooling – Paving the path toward sustainable cooling of buildings , 2011 .

[17]  Shailesh Kumar,et al.  An experimental study of a novel dew point evaporative cooling system , 2010 .

[18]  R. Shah.  Laminar Flow Forced convection in ducts , 1978 .

[19]  Saffa Riffat,et al.  Experimental and numerical investigation of a dew-point cooling system for thermal comfort in buildings , 2014 .

[20]  Xudong Zhao,et al.  Energy saving potential of a counter-flow regenerative evaporative cooler for various climates of China: Experiment-based evaluation , 2017 .

[21]  Wenming Yang,et al.  Numerical simulation of a novel energy-efficient dew-point evaporative air cooler , 2014 .

[22]  Yang Hongxing,et al.  An analytical model for the heat and mass transfer processes in indirect evaporative cooling with parallel/counter flow configurations , 2006 .