This work was focused on the development of a micropump that allows the transport of fluids with high viscosities or fluids containing pigments in a large amount. This new pump should be produced by means of silicon micromachining technologies. Due to adhesion forces as well as sedimentation processes the transport of highly viscous and particle loaded fluids is a difficult problem. Dead volumes must be surely avoided in the pump because they are preferred regions of adhesion and sedimentation, respectively. The developed micropump is nearly free of dead volumes. It consists of silicon chips and a PTFE-membrane bonded together without real gluing procedures. The silicon chips contain deep etched structures manufactured by simple wet chemical etching procedures. Pressure on the liquid can be generated inside the structures by pushing the elastic membrane. A pneumatic drive was used to deflect the membranes. In a peristaltic mode it was possible to pump liquids like honey or mustard with a noticeable flow rat up to 0.6 ml/min without any back flow.
[1]
Roland Zengerle,et al.
A new micropump with bidirectional fluid transport and selfblocking effect
,
1996,
Proceedings of Ninth International Workshop on Micro Electromechanical Systems.
[2]
W. Ehrfeld,et al.
Fabrication of Components and Systems for Chemical and Biological Microreactors
,
1998
.
[3]
P. Woias,et al.
A self-priming and bubble-tolerant piezoelectric silicon micropump for liquids and gases
,
1998,
Proceedings MEMS 98. IEEE. Eleventh Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Systems (Cat. No.98CH36176.