Simulation of Vortex Heat Transfer Enhancement in the Turbulent Water Flow in the Narrow Plane-Parallel Channel with an Inclined Oval-trench Dimple of Fixed Depth and Spot Area

This article is devoted to the development of the multiblock technique for numerical simulation of vortex heat transfer enhancement (VHTE) by inclined oval-trench dimples. Special attention is paid both to the analysis of numerical predictions of different-type boundary conditions at the wall: T = const and q = const and to the comparison of the standard and modified shear stress transport models. The article discusses the mechanism of change in the flow structure and secondary flow augmentation due to an increase in a relative length of an oval-trench dimple (at its fixed spot area, depth and orientation) where a long spiral vortex is formed.

[1]  S. A. Isaev,et al.  Correction of the Shear-Stress-Transfer Model with Account of the Curvature of Streamlines in Calculating Separated Flows of an Incompressible Viscous Fluid , 2014 .

[2]  C. Rhie,et al.  A numerical study of the turbulent flow past an isolated airfoil with trailing edge separation , 1982 .

[3]  Hyung Hee Cho,et al.  Heat transfer with dimple/protrusion arrays in a rectangular duct with a low Reynolds number range , 2008 .

[4]  Boo Cheong Khoo,et al.  Development of flow structures over dimples , 2014 .

[5]  P. A. Baranov,et al.  Vortex heat transfer enhancement in the narrow plane-parallel channel with the oval-trench dimple of fixed depth and spot area , 2017 .

[6]  Joel H. Ferziger,et al.  Computational methods for fluid dynamics , 1996 .

[7]  Gazi I. Mahmood,et al.  Heat transfer in a channel with dimples and protrusions on opposite walls , 2001 .

[8]  Nicholas Syred,et al.  Effect of Surface Curvature on Heat Transfer and Hydrodynamics Within a Single Hemispherical Dimple , 2000 .

[9]  M. L. Hill,et al.  Flow structure due to dimple depressions on a channel surface , 2001 .

[10]  Egon Hassel,et al.  Influence of the Reynolds number and the spherical dimple depth on turbulent heat transfer and hydraulic loss in a narrow channel , 2010 .

[11]  A. I. Leontiev,et al.  Turbulent flow friction and heat transfer characteristics for spherical cavities on a flat plate , 1993 .

[12]  G. Mahmood,et al.  Heat transfer in a dimpled channel: combined influences of aspect ratio, temperature ratio, Reynolds number, and flow structure , 2002 .

[13]  G. A. Dreitser.  Problems in developing highly efficient tubular heat exchangers , 2006 .

[14]  S. A. Isaev,et al.  Complex analysis of turbulence models, algorithms, and grid structures at the computation of recirculating flow in a cavity by means of VP2/3 and fluent packages. Part 2. Estimation of models adequacy , 2006 .

[15]  S. A. Isaev,et al.  Numerical Modeling of a Turbulent Incompressible Viscous Flow Along Bodies of a Curvilinear Shape in the Presence of a Mobile Shield , 1998 .

[16]  B. Launder,et al.  The numerical computation of turbulent flows , 1990 .

[17]  A. A. Khalatov,et al.  Flow regimes in a single dimple on the channel surface , 2010 .

[18]  Phillip M. Ligrani,et al.  Flow structure and local Nusselt number variations in a channel with dimples and protrusions on opposite walls , 2001 .

[19]  Her Mann Tsai,et al.  Effect of rounded edged dimple arrays on the boundary layer development , 2009, J. Vis..

[20]  S. A. Isaev,et al.  Transformation and intensification of tornado-like flow in a narrow channel during elongation of an oval dimple with constant area , 2015 .

[21]  Wolfgang Rodi,et al.  Calculation of Annular and Twin Parallel Jets Using Various Discretization Schemes and Turbulence-Model Variations , 1981 .

[22]  Nikolai Kornev,et al.  Study of Near Wall Coherent Flow Structures on Dimpled Surfaces Using Unsteady Pressure Measurements , 2013 .

[23]  Munehiko Hiwada,et al.  Some Characteristics of Flow Pattern and Heat Transfer past a Circular Cylindrical Cavity , 1983 .

[24]  A. P. Kozlov,et al.  Convective heat transfer in turbulized flow past a hemispherical cavity , 1993 .

[25]  Viktor I. Terekhov,et al.  Heat Transfer Coefficient and Aerodynamic Resistance on a Surface with a Single Dimple , 1997 .

[26]  Hyung Hee Cho,et al.  Measurement of local heat/mass transfer coefficients on a dimple using naphthalene sublimation , 2011 .

[27]  S. V. Guvernyuk,et al.  Ensuring safe descend of reusable rocket stages – Numerical simulation and experiments on subsonic turbulent air flow around a semi-circular cylinder at zero angle of attack and moderate Reynolds number , 2017, Acta Astronautica.

[28]  Srinath V. Ekkad,et al.  Dimple Enhanced Heat Transfer in High Aspect Ratio Channels , 2003 .

[29]  Coleman duP. Donaldson,et al.  Observation of a bistable flow in a hemispherical cavity. , 1966 .

[30]  B. V. Leer,et al.  Towards the ultimate conservative difference scheme V. A second-order sequel to Godunov's method , 1979 .

[31]  S. A. Isaev,et al.  Numerical simulation of the turbulent air flow in the narrow channel with a heated wall and a spherical dimple placed on it for vortex heat transfer enhancement depending on the dimple depth , 2016 .

[32]  S. A. Isaev,et al.  Numerical Simulation of Vortex Enhancement of Heat Transfer under Conditions of Turbulent Flow Past a Spherical Dimple on the Wall of a Narrow Channel , 2003 .

[33]  I. A. Gachechiladze,et al.  Self-Organization of Tornado-Like Jets in Flows of Gases and Liquids and the Technologies Utilizing This Phenomenon , 2009 .

[34]  S. A. Isaev,et al.  Analysis of errors of multiblock computational technologies by the example of calculating a circulation flow in a square cavity with a moving cover at Re = 103 , 2013 .

[35]  Florian Menter,et al.  The SST Turbulence Model with Improved Wall Treatment for Heat Transfer Predictions in Gas Turbines , 2003 .

[36]  Viktor I. Terekhov,et al.  Pressure field and resistance of a single cavity with sharp and rounded edges , 1993 .

[37]  Phil Ligrani,et al.  Comparison of Heat Transfer Augmentation Techniques , 2003 .

[38]  B. Launder,et al.  THE NUMERICAL COMPUTATION OF TURBULENT FLOW , 1974 .

[39]  F. Menter.  ZONAL TWO EQUATION k-w TURBULENCE MODELS FOR AERODYNAMIC FLOWS , 1993 .

[40]  Qiang Zhang,et al.  Thermal performance of dimpled surfaces in laminar flows , 2009 .

[41]  B. P. Leonard,et al.  A stable and accurate convective modelling procedure based on quadratic upstream interpolation , 1990 .

[42]  K. H. Presser.  Empirische gleichungen zur berechnung der stoff- und wärmeübertragung für den spezialfall der abgerissenen strömung , 1972 .

[43]  Minking K. Chyu,et al.  Heat Transfer Enhancement in Rectangular Channels with Concavities , 1999 .

[44]  G. Hetsroni.  Handbook of hydraulic resistance , 1990 .

[45]  S. A. Isaev,et al.  Local heat fluxes on the surfaces of dimples, ditches, and cavities , 2007 .

[46]  Di Zhang,et al.  Effect of leading edge boundary layer thickness on dimple flow structure and separation control , 2011 .

[47]  Florian R. Menter,et al.  Sensitization of the SST Turbulence Model to Rotation and Curvature by Applying the Spalart-Shur Correction Term , 2008 .

[48]  C. Rhie,et al.  Numerical Study of the Turbulent Flow Past an Airfoil with Trailing Edge Separation , 1983 .

[49]  Yousef Saad,et al.  Iterative methods for sparse linear systems , 2003 .

[50]  S. A. Isaev,et al.  Verification of the Shear-Stress Transfer Model and its Modifications in the Calculation of a Turbulent Flow Around a Semicircular Airfoil with a Zero Angle of Attack , 2016 .

[51]  F. Menter,et al.  Ten Years of Industrial Experience with the SST Turbulence Model , 2003 .

[52]  Yao Zheng,et al.  A novel approach of three-dimensional hybrid grid methodology: Part 1. Grid generation , 2003 .

[53]  P. Spalart,et al.  On the sensitization of turbulence models to rotation and curvature , 1997 .

[54]  S. A. Isaev,et al.  Numerical study of the bleeding effect on the aerodynamic characteristics of a circular cylinder , 2002 .

[55]  Hrvoje Jasak,et al.  Error analysis and estimation for the finite volume method with applications to fluid flows , 1996 .

[56]  Beom-Soo Kang,et al.  Formability evaluation of dimple forming process based on numerical and experimental approach , 2011 .

[57]  S. A. Isaev,et al.  Simulation of the Turbulent air Flow Over a Circular Cavity with a Variable Opening Angle in an U-Shaped Channel , 2015 .

[58]  J. P. V. Doormaal,et al.  ENHANCEMENTS OF THE SIMPLE METHOD FOR PREDICTING INCOMPRESSIBLE FLUID FLOWS , 1984 .