Potential catalyst savings in heterogeneous gaseous spiral coiled reactor utilizing selective wall coating - A computational study

Abstract This study numerically evaluates the effect of secondary flow on the reaction performance in heterogeneous gaseous spiral coiled reactor utilizing selective wall coatings. Laminar multispecies gas flow in spiral coiled reactor with circular and square cross-section is investigated using a validated three-dimensional computational fluid dynamics (CFD) model. Various selective wall coating strategies are evaluated within a range of Reynolds number. The reactor performance is measured not only based on the conversion rate but also in terms of figure of merit (FoM) defined as reaction throughput per unit pumping power and catalyst coating active area. The results indicate that secondary flow enhance reaction performance and improve catalyst utilization, especially at the outer wall. By maximizing this effect, the requirement of expensive catalyst materials can be minimized. This study highlight the potential of selective catalyst coating in coiled reactor for process intensification and cost reduction in various applications.

[1]  Yannick Hoarau,et al.  Numerical modeling of polystyrene synthesis in coiled flow inverter , 2011 .

[2]  Hossein Shokouhmand,et al.  Entropy generation analysis of fully developed laminar forced convection in a helical tube with uniform wall temperature , 2007 .

[3]  A. Mujumdar,et al.  Laminar convective heat transfer for in-plane spiral coils of noncircular cross sections ducts: A computational fluid dynamics study , 2012 .

[4]  M. Paraschivoiu,et al.  Single-phase fluid flow and mixing in microchannels , 2011 .

[5]  A. Jess,et al.  Kinetic study and H2S effect on refractory DBTs desulfurization in a heavy gasoil , 2010 .

[6]  Tom Van Gerven,et al.  Exploration of rectangular waveguides as a basis for microwave enhanced continuous flow chemistries , 2013 .

[7]  Kannan N. Iyer,et al.  CFD analysis of single-phase flows inside helically coiled tubes , 2010, Comput. Chem. Eng..

[8]  T. Liou.  Flow visualization and LDV measurement of fully developed laminar flow in helically coiled tubes , 1992 .

[9]  L. Kallinikos,et al.  Fluid dynamic characteristics of a structured bed spiral mini-reactor , 2007 .

[10]  Krishna D.P. Nigam,et al.  Modelling of a coiled tubular chemical reactor , 2001 .

[11]  Sandip Mazumder,et al.  The treatment of reacting surfaces for finite-volume schemes on unstructed meshes , 2001 .

[12]  A. Mujumdar,et al.  a Phenomenological Model for Hydrogels with Rigid Skin Formation , 2012 .

[13]  P. Naphon,et al.  Effect of curvature ratios on the heat transfer and flow developments in the horizontal spirally coiled tubes , 2007 .

[14]  Paolo Canu,et al.  Simulation and interpretation of catalytic combustion experimental data , 2001 .

[15]  Robert W. Dibble,et al.  HYDROGEN ASSISTED CATALYTIC COMBUSTION OF METHANE ON PLATINUM , 2000 .

[16]  A. Sasmito,et al.  Numerical investigation of mixing performance in microchannel T-junction with wavy structure , 2014 .

[17]  M. H. Kayhani,et al.  Convective Heat Transfer of Viscoelastic Flow in a Curved Duct , 2009 .

[18]  Arun S. Mujumdar,et al.  Computational fluid dynamics (CFD) analysis of micro-reactor performance: Effect of various configurations , 2012 .

[19]  Tami C. Bond,et al.  Catalytic oxidation of natural gas over supported platinum: Flow reactor experiments and detailed numberical modeling , 1996 .

[20]  Louis C. Burmeister,et al.  Heat Transfer for Laminar Flow in Spiral Ducts of Rectangular Cross Section , 2005 .

[21]  Krishna D.P. Nigam,et al.  Coiled flow inverter as an inline mixer , 2008 .

[22]  A. Mujumdar,et al.  Numerical investigation of laminar mass transport enhancement in heterogeneous gaseous microreactors , 2012 .

[23]  Somchai Wongwises,et al.  A review of flow and heat transfer characteristics in curved tubes , 2006 .

[24]  Krishna D.P. Nigam,et al.  A Review on the Potential Applications of Curved Geometries in Process Industry , 2008 .

[25]  Arun S. Mujumdar,et al.  Numerical Evaluation of Transport Phenomena in a T-junction Microreactor with Coils of Different Configurations , 2012 .

[26]  Laxminarayan L. Raja,et al.  A critical evaluation of Navier–Stokes, boundary-layer, and plug-flow models of the flow and chemistry in a catalytic-combustion monolith , 2000 .

[28]  Yuan Zhou,et al.  CFD study of heat transfer for oscillating flow in helically coiled tube heat-exchanger , 2014, Comput. Chem. Eng..

[29]  Arun S. Mujumdar,et al.  Evaluation of mass transport performance in heterogeneous gaseous in-plane spiral reactors with various cross-section geometries at fixed cross-section area , 2014 .

[30]  K. Nigam,et al.  Fluid Flow and Heat Transfer in Curved Tubes with Temperature-Dependent Properties , 2007 .