Comparison of the Intrinsic Characteristics of LTCC and Silicon Pressure Sensors by Means of 1/f Noise Measurements

A pressure sensor with high resolution is of key importance for precise measurements in the low-pressure range. The intrinsic resolution of piezoresistive ceramic pressure sensors (CPSs) mainly depends on their func- tional sensitivity and the electronic noise in the thick-film resistors. Both the sensitivity and the noise level depend on the material and the structural properties, and the dimen- sions of the sensing structure. In general, the sensitivity can be increased and the noise can be reduced by using additional electronics for the signal processing, but this makes the sensor bigger, more complex and more expen- sive. In this study we discuss the technological limits for downscaling the sensor's pressure range without any processing of the sensor's signal. The intrinsic resolution of the piezoresistive pressure sensors designed for the pressure range 0 to ±100 mbar and realized in LTCC (Low Temperature Cofired Ceramic) technology was evaluated and compared to the resolution of a commercial 100-mbar silicon pressure sensor. Considering their different typical sensitivities, the resolutions of about 0.02 mbar and 0.08 mbar were obtained for the CPS and the silicon sen- sors, respectively. The low-frequency noise measurements showed that the noise characteristics of both sensors were not influenced by the pressure loads.

[1]  M. Hrovat,et al.  A characterisation of thick film resistors for strain gauge applications , 2001 .

[2]  Marina Santo Zarnik,et al.  Stability of a Piezoresistive Ceramic Pressure Sensor Made With LTCC Technology , 2012 .

[3]  Adsorption–desorption noise can be used for improving selectivity , 2002, physics/0212088.

[4]  Kyihwan Park,et al.  Design optimization of a piezoresistive pressure sensor considering the output signal-to-noise ratio , 2004 .

[5]  L. Hasse,et al.  Comparison of effectiveness of gas sensing by low frequency fluctuations in resistance and microbalance quartz gas sensors , 2011, 2011 21st International Conference on Noise and Fluctuations.

[6]  Janusz Smulko.  Electrochemical noise analysis methods for the investigation of corrosion processes , 2003, SPIE International Symposium on Fluctuations and Noise.

[7]  K. Aguir,et al.  Adsorption–desorption noise in gas sensors: Modelling using Langmuir and Wolkenstein models for adsorption , 2006 .

[8]  Peter Händel,et al.  Adsorption–desorption noise in QCM gas sensors , 2012 .

[9]  M. Hrovat,et al.  Evaluation of piezoresistive ceramic pressure sensors using noise measurements , 2012 .

[10]  Josef Sikula,et al.  Reliability of electronic devices: Failure mechanisms and testing , 2009 .

[11]  Giancarlo Corradini,et al.  Design and characterisation of low-cost thick-film piezoresistive force sensors for the 100 mN to 100 N range , 2005 .

[12]  Srecko Macek,et al.  The warm-up and offset stability of a low-pressure piezoresistive ceramic pressure sensor , 2010 .

[13]  Josef Sikula,et al.  Low-frequency noise of thick-film resistors as quality and reliability indicator , 2001, Microelectron. Reliab..