The Next Generation Space Telescope will provide at least ten times the collecting area of the Hubble Space Telescope in a package that fits into the shroud of an expendable launch vehicle. The resulting large, flexible structure provides a challenge to the design of a pointing control system for which the requirements are at the milli-arcsecond level. This paper describes a design concept in which pointing stability is achieved by means of a nested-loop design involving an inertial attitude control system (ACS) and a fast steering mirror (FSM). A key to the integrated control design is that the ACS controllers has a bandwidth well below known structural modes and the FSM uses a rotationally balanced mechanism which should not interact with the flexible modes that are within its control bandwidth. The ACS controller provides stable pointing of the spacecraft bus with star trackers and gyros. This low bandwidth loop uses nearly co-located sensors and actuators to slew and acquire faint guide stars in the NIR camera. This controller provides a payload reference stable to the arcsecond level. Low-frequency pointing errors due to sensor noise and dynamic disturbances are suppressed by a 2-axis gimbaled FSM locate din the instrument module. The FSM servo bandwidth of 6 Hz is intended to keep the guide star position stable in the NIR focal plane to the required milli-arcsecond level. The mirror is kept centered in its range of travel by a low-bandwidth loop closed around the ACS. This paper presents the result of parametric trade studies designed to assess the performance of this control design in the presence of modeled reaction wheel disturbances, assumed to be the principle source of vibration for the NGST, and variations in structural dynamics. Additionally, requirements for reaction wheel disturbance levels and potential vibration isolation subsystems were developed.
[1]
David C. Redding,et al.
Integrated modeling environment for systems-level performance analysis of the Next-Generation Space Telescope
,
1998,
Astronomical Telescopes and Instrumentation.
[2]
Frank H. Bauer,et al.
Attitude control system conceptual design for the X-ray timing explorer
,
1992
.
[3]
Lawrence M. Germann,et al.
Active isolation systems
,
1993,
Defense, Security, and Sensing.
[4]
J. W. Murrell,et al.
Precision attitude determination for multimission spacecraft
,
1978
.
[5]
J. Spanos,et al.
A soft 6-axis active vibration isolator
,
1995,
Proceedings of 1995 American Control Conference - ACC'95.
[6]
R. Farrenkopf.
Analytic Steady-State Accuracy Solutions for Two Common Spacecraft Attitude Estimators
,
1978
.
[7]
David L. Kaplan.
Fast steering mirror performance measurements
,
1993,
Smart Structures.