A comparison of wind turbine design loads in different environments using inverse reliability techniques

The influence of turbulence conditions on the design loads for wind turbines is investigated by using inverse reliability techniques. Alternative modeling assumptions for randomness in the gross wind environment and in the extreme response given wind conditions to establish nominal design loads are studied. Accuracy in design load predictions based on use of the inverse first-order reliability method (that assumes a linearized limit state surface) is also investigated. An example is presented where three alternative nominal load definitions are used to estimate extreme flapwise bending loads at a blade root for a 600 kW three-bladed, stall-regulated horizontal-axis wind turbine located at onshore and offshore sites that were assumed to experience the same mean wind speed but different turbulence intensities. It is found that second-order (curvature-type) corrections to the linearized limit state function assumption inherent in the inverse first-order reliability approach are insignificant. Thus, we suggest that the inverse first-order reliability method is an efficient and accurate technique of predicting extreme loads. Design loads derived from a full random characterization of wind conditions as well as short-term maximum response (given wind conditions) may be approximated reasonably well by simpler models that include only the randomness in the wind environment but account for response variability by employing appropriately derived ‘‘higher-than-median’’ fractiles of the extreme bending loads conditional on specified inflow parameters. In the various results discussed, it is found that the higher relative turbulence at the onshore site leads to larger blade bending design loads there than at the offshore site. Also, for both onshore and offshore environments accounting for response variability is found to be slightly more important at longer return periods (i.e., safer designs). @DOI: 10.1115/1.1796971#