The effect of A-site doping in a strontium palladium perovskite and its applications for non-enzymatic glucose sensing

The catalytic activity of a strontium palladium perovskite, Sr2PdO3, toward non-enzymatic glucose sensing is strongly affected by the Sr2+ A-site partial substitution by Ca2+ ions; Sr2−xCaxPdO3 with x = 0–0.7. Scanning and transmission electron microscopies (SEM, EDAX and TEM), XRD, XPS, BET and a particle size analyzer were used to investigate the microstructure, morphology, physical–chemical and electrochemical properties of the prepared perovskites. A good-crystalline orthorhombic Sr2PdO3 phase was formed as the main phase in all the prepared samples with particle sizes in the range of nanometers as confirmed by XRD. Doping the A-site Sr2+ cations with Ca2+ ions in the Sr2PdO3 perovskite leads to the enhancement of the elecrocatalytic activity towards non-enzymatic glucose sensing showing the highest elecrocatalytic activity in the case of Sr1.7Ca0.3PdO3. This may be attributed to the higher free volume in the crystal lattice, enhanced content and mobility of surface lattice oxygen and distorted stabilized perovskite structure leading to higher catalytic activity of the prepared perovskites. In addition, synergistic interactions were achieved between Sr2+ and Ca2+ in the A-site and Pd2+ ions in the B-site resulting in improved surface activity and a stabilized structure. As a result, greater ionic and electronic conductivity and enhanced catalytic activity were achieved upon doping. Graphite/Sr1.7Ca0.3PdO3 as a free enzymatic glucose sensor exhibited good stability, a low detection limit, high sensitivity, good selectivity even in the presence of common interferents, applicability in real sample analysis and anti-interference ability.

[1]  A. Galal,et al.  Electrocatalytic evolution of hydrogen on a novel SrPdO3 perovskite electrode , 2010 .

[2]  Yaping Ding,et al.  A novel nonenzymatic sensor based on LaNi0.6Co0.4O3 modified electrode for hydrogen peroxide and glucose. , 2012, Analytica chimica acta.

[3]  W. Hwang,et al.  Enhancement of luminescence properties via the substitution of Ba2+ by Sr2+ and Ca2+ in the white phosphors Ba1−yMyLa2−xWO7:xDy3+ (M=Sr, Ca) (x=0.01–0.4, y=0–0.4) , 2012 .

[4]  C. Au,et al.  Lattice oxygen of La1−xSrxMO3 (M = Mn, Ni) and LaMnO3−αFβ perovskite oxides for the partial oxidation of methane to synthesis gas , 2008 .

[5]  Qinglu Li,et al.  Electrodeposition of platinum on poly(glutamic acid) modified glassy carbon electrode for non-enzymatic amperometric glucose detection , 2013 .

[6]  Xiaojuan Liu,et al.  A novel sensitive nonenzymatic glucose sensor based on perovskite LaNi0.5Ti0.5O3-modified carbon paste electrode , 2010 .

[7]  O. Muller,et al.  Synthesis and Crystal Chemistry of Some New Complex Palladium Oxides , 1971 .

[8]  E. Takayama-Muromachi,et al.  Oxyfluoride Chemistry of Layered Perovskite Compounds , 2012 .

[9]  A. Giroir‐Fendler,et al.  The effect of A-site substitution by Sr, Mg and Ce on the catalytic performance of LaMnO3 catalysts for the oxidation of vinyl chloride emission , 2013 .

[10]  V. Shustov,et al.  Delocalization of the Cu2+Unpaired Electron on the Next Nearest Ligands in Sr2Pd0.99Cu0.01O3Ceramics , 2008 .

[11]  Munetaka Oyama,et al.  Nonenzymatic amperometric sensing of glucose by using palladium nanoparticles supported on functional carbon nanotubes. , 2010, Biosensors & bioelectronics.

[12]  Seong-soo Hong,et al.  Simultaneous removal of NO and carbon particulates over lanthanoid perovskite-type catalysts , 2000 .

[13]  Yu Lin,et al.  Pd-integrated lanthanum-transition metal perovskites for methanol partial oxidation , 2011 .

[14]  A. Galal,et al.  Nano-perovskite carbon paste composite electrode for the simultaneous determination of dopamine, ascorbic acid and uric acid , 2014 .

[15]  D. Wong,et al.  Cathodic deposition of binary nickel-cobalt hydroxide for non-enzymatic glucose sensing , 2014 .

[16]  Shaomin Liu,et al.  Bi-doping effects on the structure and oxygen permeation properties of BaSc0.1Co0.9O3−δ perovskite membranes , 2010 .

[17]  Zongping Shao,et al.  Efficient stabilization of cubic perovskite SrCoO3−δ by B-site low concentration scandium doping combined with sol–gel synthesis , 2008 .

[18]  Xiong Yin,et al.  Modification of B-site doping of perovskite LaxSr1 − xFe1 − y−zCoyCrzO3 − δ oxide by Mg2+ ion , 2009 .

[19]  P. Svedlindh,et al.  Effets of A-site substitution on the structure and magnetic properties of Bi0.15Sr0.85-yAeyCo1-xFexO3-o , 2009 .

[20]  Xiaoya Hu,et al.  Construction of a non-enzymatic glucose sensor based on copolymer P4VP-co-PAN and Fe2O3 nanoparticles. , 2014, Materials science & engineering. C, Materials for biological applications.

[21]  D. Fino,et al.  Pd substitution effects on perovskite catalyst activity for methane emission control , 2009 .

[22]  Zhaoqiang Li,et al.  Fe-substituted nanometric La0.9K0.1Co1−xFexO3−δ perovskite catalysts used for soot combustion, NOx storage and simultaneous catalytic removal of soot and NOx , 2010 .

[23]  M. El‐Kady,et al.  Poly(3-methylthiophene)/palladium sub-micro-modified sensor electrode. Part II: Voltammetric and EIS studies, and analysis of catecholamine neurotransmitters, ascorbic acid and acetaminophen. , 2009, Talanta.

[24]  Xiang Gao,et al.  Simultaneous catalytic removal of NOx and diesel soot particulates over La2 − xAxNi1 − yByO4 perovskite-type oxides , 2011 .

[25]  A. Galal,et al.  The Electrochemistry and Determination of Some Neurotransmitters at SrPdO3 Modified Graphite Electrode , 2013 .

[26]  D. Ma,et al.  Laser synthesis and tailor-design of nanosized gold onto carbon nanotubes for non-enzymatic electrochemical glucose sensor , 2014 .

[27]  Yunbin He,et al.  Gold nanoparticles directly modified glassy carbon electrode for non-enzymatic detection of glucose , 2014 .

[28]  Masatsugu Oishi,et al.  Oxygen nonstoichiometry and defect structure analysis of B-site mixed perovskite-type oxide (La, Sr)(Cr, M)O3−δ (M=Ti, Mn and Fe) , 2008 .

[29]  Wenli Song,et al.  Influence of Pr-doping on structural, electronic transport, magnetic properties of perovskite molybdates Sr1-xPrxMoO3 (0≤x≤0.15) , 2006 .

[30]  Y. Chu,et al.  A novel route to prepare LaNiO3 perovskite-type oxide nanofibers by electrospinning for glucose and hydrogen peroxide sensing. , 2013, The Analyst.

[31]  Q. Xie,et al.  Facile fabrication of network film electrodes with ultrathin Au nanowires for nonenzymatic glucose sensing and glucose/O2 fuel cell. , 2014, Biosensors & bioelectronics.

[32]  Dan Xiao,et al.  A sensitive AgNPs/CuO nanofibers non-enzymatic glucose sensor based on electrospinning technology , 2014 .

[33]  F. Chen,et al.  Ba1−xCo0.9−yFeyNb0.1O3−δ (x = 0–0.15, y = 0–0.9) as cathode materials for solid oxide fuel cells , 2011 .

[34]  V. Zaspalis,et al.  La1−xSrxFeO3−δ perovskites as redox materials for application in a membrane reactor for simultaneous production of pure hydrogen and synthesis gas , 2010 .

[35]  R. D. Shannon,et al.  Effective ionic radii in oxides and fluorides , 1969 .

[36]  Xi Chen,et al.  Non-enzymatic electrochemical glucose sensor based on platinum nanoflowers supported on graphene oxide. , 2013, Talanta.

[37]  P. Wakeley,et al.  Synthesis , 2013, The Role of Animals in Emerging Viral Diseases.

[38]  Sundaram Gunasekaran,et al.  Nickel nanoparticle-chitosan-reduced graphene oxide-modified screen-printed electrodes for enzyme-free glucose sensing in portable microfluidic devices. , 2013, Biosensors & bioelectronics.

[39]  B. Saruhan,et al.  Effect of Fe/Co-ratio on the phase composition of Pd-integrated perovskites and its H2-SCR of NOx performance , 2010 .

[40]  J. Goodenough,et al.  A Perovskite Oxide Optimized for Oxygen Evolution Catalysis from Molecular Orbital Principles , 2011, Science.

[41]  R. Singh,et al.  High surface area lanthanum cobaltate and its A and B sites substituted derivatives for electrocatalysis of O2 evolution in alkaline solution , 2002 .

[42]  S. Mahshid,et al.  Electrodeposition and electrocatalytic properties of Pt/Ni–Co nanowires for non-enzymatic glucose detection , 2013 .

[43]  Y. Yang,et al.  Enzyme-free sensing of hydrogen peroxide and glucose at a CuS nanoflowers modified glassy carbon electrode , 2014 .

[44]  M. Mogensen,et al.  Conductivity of A- and B-site doped LaAlO3, LaGaO3, LaScO3 and LaInO3 perovskites , 2000 .

[45]  W. Shi,et al.  Effects of doping site and pre-sintering time on microstructure and magnetic properties of Fe-doped BaTiO3 ceramics , 2012 .

[46]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[47]  A. Petric,et al.  Oxygen conductivity of Nd(Sr/Ca)Ga(Mg)O3−δ perovskites , 1996 .

[48]  Kebin Zhou,et al.  Synergistic effect of palladium and oxygen vacancies in the Pd/perovskite catalysts synthesized by the spc method. , 2005, Journal of environmental sciences.

[49]  R. Singh,et al.  Effect of cation doping on low-temperature specific heat of LaMnO3 manganite , 2008 .

[50]  Xueqin Zhang,et al.  Structure, morphology and electrochemical properties of LaxSr1−xCo0.1Mn0.9O3−δ perovskite nanofibers prepared by electrospinning method , 2015 .

[51]  B. Delmon,et al.  Activity in methane combustion and sensitivity to sulfur poisoning of La1-xCexMn1-yCoyO3 perovskite oxides , 2003 .

[52]  J. Long,et al.  Dimensional Reduction: A Practical Formalism for Manipulating Solid Structures , 2001 .

[53]  J. Kuhn,et al.  Effect of additional B-site transition metal doping on oxygen transport and activation characteristi , 2011 .

[54]  Ekram H. El-Ads,et al.  Electrochemistry of glucose at gold nanoparticles modified graphite/SrPdO3 electrode – Towards a novel non-enzymatic glucose sensor , 2015 .

[55]  Li Wang,et al.  Dendritic copper-cobalt nanostructures/reduced graphene oxide-chitosan modified glassy carbon electrode for glucose sensing , 2014 .

[56]  Young Sun,et al.  Structural, magnetic, and electrical properties of La1−xNdxMn0.8Cr0.2O3 (x⩽0.3) , 2007 .

[57]  J. Stevenson,et al.  High performance ceramic interconnect material for solid oxide fuel cells (SOFCs): Ca- and transition metal-doped yttrium chromite , 2011 .

[58]  H. Inaba,et al.  Structural phase transition of perovskite oxides LaMO3 and La0.9Sr0.1MO3 with different size of B-site ions , 2001 .

[59]  Shen-ming Chen,et al.  A highly sensitive nonenzymatic glucose sensor based on multi-walled carbon nanotubes decorated with nickel and copper nanoparticles , 2013 .

[60]  A. Kawahara,et al.  Perovskite membrane of La1−xSrxTi1−yFeyO3−δ for partial oxidation of methane to syngas , 2010 .

[61]  Andrew G. Glen,et al.  APPL , 2001 .