Active disturbance rejection control for stand-alone doubly fed induction generator

In this paper, a controller design method is proposed for stand-alone doubly fed induction generator (DFIG). This method is based on forced stator-voltage-oriented vector control principle and active disturbance rejection control (ADRC) approach. Specifically, the forced stator-voltage-oriented vector control principle is used to simplify the mathematics model of stand-alone DFIG and guarantee constant frequency. ADRC approach is used to obtain the constant amplitude of the stator voltage with the variable load. The proposed strategy has a good transient at the start-up and the load changes condition. Simulation results are given to illustrate the efficacy of the proposed method.

[1]  R. W. De Doncker,et al.  Doubly fed induction generator systems for wind turbines , 2002 .

[2]  Chen Jian.  Research on Vector Control for Stand-Alone Doubly Fed Generator , 2007 .

[3]  Greg Asher,et al.  A doubly fed induction generator using back-to-back PWM converters supplying an isolated load from a variable speed wind turbine , 1996 .

[4]  W. Koczara,et al.  Sensorless direct voltage control method for stand-alone slip-ring induction generator , 2005, 2005 European Conference on Power Electronics and Applications.

[5]  Jon Clare,et al.  Doubly fed induction generator using back-to-back PWM converters and its application to variable-speed wind-energy generation , 1996 .

[6]  Cristian Lascu,et al.  Sliding-mode observer and improved integrator with DC-offset compensation for flux estimation in sensorless-controlled induction motors , 2006, IEEE Transactions on Industrial Electronics.

[7]  Yuan Guofeng,et al.  Vector control of a doubly fed induction generator for stand-alone ship shaft generator systems , 2007, 2007 International Conference on Electrical Machines and Systems (ICEMS).

[8]  Nicolas Patin,et al.  Modeling and Control of a Cascaded Doubly Fed Induction Generator Dedicated to Isolated Grids , 2009, IEEE Transactions on Industrial Electronics.

[9]  Huan Yang,et al.  Improved voltage vector control for a stand-alone DFIG system based on predictive current regulation algorithm , 2014, 2014 17th International Conference on Electrical Machines and Systems (ICEMS).

[10]  Roberto Cardenas,et al.  A constant frequency constant voltage variable speed stand alone wound rotor induction generator , 1996 .

[11]  Tamou Nasser,et al.  A Linear Active Disturbance Rejection Control applied for DFIG based Wind Energy Conversion System , 2013 .

[12]  Yushi Miura,et al.  Direct Voltage Control With Slip Angle Estimation to Extend the Range of Supported Asymmetric Loads for Stand-Alone DFIG , 2016, IEEE Transactions on Power Electronics.

[13]  Li Fahai.  New integral error correction method for rotor flux identification of AC drives , 2001 .

[14]  Yao Sun,et al.  Coordinated control for unbalanced operation of stand‐alone doubly fed induction generator , 2014 .

[15]  Li Dan-Yun,et al.  Repetitive control of the stator-side four-leg converter in stand-alone DFIG-based wind energy conversion system , 2015, 2015 34th Chinese Control Conference (CCC).