On-line anomaly detection for the measurement error of HVPT in the multi-bus structure

Abstract As the key metering equipment of the high-voltage transmission network, the high-voltage potential transformer (HVPT) needs manual maintenance to ensure that its operating status complies with relevant regulations. Due to the requirement of power outages, the manual maintenance could only be conducted at regular intervals and the measurement error of HVPT remains unknown during the operation. To address the issue, this paper proposes an on-line anomaly detection method for the measurement error of HVPT with high applicability to the complex power system. By taking advantage of the multi-bus structure, the abnormal HVPTs can be detected and located based on the in-phase relation between the HVPTs connected to the same phase and the three-phase relation within the HVPT groups. This method is data-driven and will not affect the operation of the power system. The effectiveness of the proposed method is verified in a 220 kV substation.

[1]  Qing Chen,et al.  Research on the reliability of capacitor voltage transformers calibration results , 2019, Measurement.

[2]  Lu Fang,et al.  Calibration method of capacitive electronic voltage transformer in smart substation , 2012 .

[3]  L. Pierrat,et al.  A Method Integrating Deterministic and Stochastic Approaches for the Simulation of Voltage Unbalance in Electric Power Distribution Systems , 2001 .

[4]  Marcelo Martins Werneck,et al.  A temperature-independent optical voltage transformer based on FBG-PZT for 13.8 kV distribution lines , 2019 .

[5]  Zhi Zhang,et al.  High-accuracy online calibration system for electronic voltage transformers with digital output , 2014 .

[6]  Ting Lei,et al.  On-line fault detection technique for voltage transformers , 2017 .

[7]  Stefan Siegenthaler,et al.  A Computer-Controlled Calibrator for Instrument Transformer Test Sets , 2016, IEEE Transactions on Instrumentation and Measurement.

[8]  Yan Xu,et al.  Research on Proximity Effect in Measuring Error of Active Electronic Voltage Transformers , 2016, IEEE Transactions on Instrumentation and Measurement.

[9]  Roberto Ottoboni,et al.  A Simple Method for the Calibration of Traditional and Electronic Measurement Current and Voltage Transformers , 2009, IEEE Transactions on Instrumentation and Measurement.

[10]  Chen Weigen,et al.  Research on the measurement error of capacitor voltage transformer under various insulation characteristics , 2016, 2016 IEEE International Conference on High Voltage Engineering and Application (ICHVE).

[11]  Chiranjib Koley,et al.  Condition monitoring of high voltage transformers using Fiber Bragg Grating Sensor , 2015 .

[12]  M. Davarpanah,et al.  Compensation of CVT Increased Error and Its Impacts on Distance Relays , 2012, IEEE Transactions on Power Delivery.

[13]  Yonghua Song,et al.  Probabilistic Load Flow Based on Generalized Polynomial Chaos , 2017, IEEE Transactions on Power Systems.

[14]  Yaw-Juen Wang,et al.  Probabilistic modeling of three-phase voltage unbalance caused by load fluctuations , 2000, 2000 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.00CH37077).

[15]  Lin Du,et al.  Measurement Error Estimation for Capacitive Voltage Transformer by Insulation Parameters , 2017 .

[16]  Dengping Tang,et al.  Monitoring the metering performance of an electronic voltage transformer on-line based on cyber-physics correlation analysis , 2017 .

[17]  Branislav Djokic,et al.  Calibration system for electronic instrument transformers with digital output , 2004, CPEM 2004.

[18]  Sang-Hee Kang,et al.  Design and evaluation of a compensating algorithm for the secondary voltage of a coupling capacitor voltage transformer in the time domain , 2009 .

[19]  Z.Q. Bo,et al.  An adaptive distance relay based on transient error estimation of CVT , 2006, IEEE Transactions on Power Delivery.

[20]  E. Sperling,et al.  Capacitive voltage transformers - electrical performance and effective diagnostic measures , 2016, 2016 International Conference on Condition Monitoring and Diagnosis (CMD).

[21]  J.G. Rolim,et al.  Reliability Centered Maintenance for Capacitor Voltage Transformers , 2006, 2006 International Conference on Probabilistic Methods Applied to Power Systems.

[22]  James S. Thorp,et al.  Online Calibration of Voltage Transformers Using Synchrophasor Measurements , 2016, IEEE Transactions on Power Delivery.

[23]  Qing Chen,et al.  Detection of the ratio error drift in CVT considering AVC , 2019, Measurement.

[24]  Luis Eduardo Mujica,et al.  Q-statistic and T2-statistic PCA-based measures for damage assessment in structures , 2011 .