Temperature dependent external quantum efficiency simulations and experimental measurement of lattice matched quantum dot enhanced multi-junction solar cells

The external quantum efficiency (EQE) of a high efficiency lattice matched multi-junction solar cell (MJSC) and a quantum dot enhanced MJSC are numerically simulated. An effective medium is developed and integrated into the model to simulate the absorption characteristics of the quantum dots in the latter device. A calibration of the model is carried out using room temperature EQE measurements of both MJSC designs. The numerical model is further generalized through the development of a novel temperature dependent absorption model based on the Varshni relation for bandgap narrowing due to temperature. Integrating this model into the numerical simulation environment accurately reproduced the experimentally observed shifts in the EQE edge of each sub-cell as a function of temperature, including the shift in the quantum dot peak. The current — voltage characteristics are discussed under the AM1.5D spectrum for concentrated illumination and realistic temperatures in concentrator systems. The development of this temperature dependent absorption model is an important addition to the set of design tools used to optimize high efficiency MJSC under realistic temperatures and spectral conditions experienced in concentrated photovoltaic systems.

[1]  Karin Hinzer,et al.  Measurement of high efficiency 1 cm2 AlGaInP/InGaAs/Ge solar cells with embedded InAs quantum dots at up to 1000 suns continuous concentration , 2010, 2010 35th IEEE Photovoltaic Specialists Conference.

[2]  D. C. Law,et al.  Band-Gap-Engineered Architectures for High-Efficiency Multijunction Concentrator Solar Cells , 2009 .

[3]  P. Würfel,et al.  Physics of solar cells , 2005 .

[4]  Karin Hinzer,et al.  Performance comparison of AlGaAs, GaAs and InGaP tunnel junctions for concentrated multijunction solar cells , 2011 .

[5]  A. Beer,et al.  Semiconductors and Semimetals. Vol. 3 Optical Properties of III–V Compounds , 1968 .

[6]  Sadao Adachi,et al.  Optical Constants of Crystalline and Amorphous Semiconductors: Numerical Data and Graphical Information , 1999 .

[7]  Karin Hinzer,et al.  Simulation, modeling, and comparison of III-V tunnel junction designs for high efficiency metamorphic multi-junction solar cells , 2010, Photonics North.

[8]  T. Hall,et al.  Efficiency Measurements and Simulations of GaInP/InGaAs/Ge Quantum Dot Enhanced Solar Cells at up to 1000‐Suns Under Flash and Continuous Concentration , 2011 .

[9]  Sadao Adachi,et al.  Optical Constants of Crystalline and Amorphous Semiconductors , 1999 .

[10]  K. Edmondson,et al.  Spectral response and energy output of concentrator multijunction solar cells , 2009 .

[11]  Karin Hinzer,et al.  Multi‐kilowatt CPV Installation Employing Low‐cost, Highly Concentrating Wave‐Guiding Optics , 2011 .

[12]  P. Hebert,et al.  Concentrator multijunction solar cell characteristics under variable intensity and temperature , 2008 .

[13]  Y. P. Varshni.  Temperature dependence of the energy gap in semiconductors , 1967 .