High-voltage gain dc–dc boost converter with coupled inductors for photovoltaic systems

This study presents the analysis, design and experimental evaluation of a high-voltage gain dc–dc converter applied to photovoltaic (PV) systems. A PV module rated at 17 V is connected to the input side, whereas the converter is responsible for stepping the voltage up to 311 V with the achievement of maximum power point tracking (MPPT). An experimental prototype rated at 100 W is implemented, which does not employ electrolytic capacitors, thus increasing the useful life of the arrangement and also allowing the incorporation of the converter to the PV module. Prominent advantages of the topology are low cost and simplicity in terms of the MPPT algorithm and the system implementation, which are mandatory characteristics for renewable energy applications.

[1]  R. Middlebrook.  Transformerless DC-to-DC converters with large conversion ratios , 1988 .

[2]  Luiz Henrique S. C. Barreto,et al.  High-Voltage Gain Boost Converter Based on Three-State Commutation Cell for Battery Charging Using PV Panels in a Single Conversion Stage , 2014, IEEE Transactions on Power Electronics.

[3]  Luowei Zhou,et al.  Interleaved high step-up zero-voltage-switching boost converter with variable inductor control , 2014 .

[4]  M. Vitelli,et al.  Optimization of perturb and observe maximum power point tracking method , 2005, IEEE Transactions on Power Electronics.

[5]  Milan M. Jovanovic,et al.  New two-inductor boost converter with auxiliary transformer , 2002, APEC. Seventeenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.02CH37335).

[6]  I. Barbi,et al.  A New Quadratic, Three-Level, DC/DC Converter Suitable for Fuel Cell Applications , 2007, 2007 Power Conversion Conference - Nagoya.

[7]  R. Teodorescu,et al.  On the Perturb-and-Observe and Incremental Conductance MPPT Methods for PV Systems , 2013, IEEE Journal of Photovoltaics.

[8]  Demercil de Souza Oliveira,et al.  Novel Nonisolated High-Voltage Gain DC–DC Converters Based on 3SSC and VMC , 2012, IEEE Transactions on Power Electronics.

[9]  C.A. Gallo,et al.  Non-isolated DC-DC converters with wide conversion range used to drive high-brightness LEDs , 2009, 2009 Brazilian Power Electronics Conference.

[10]  M. Vitelli,et al.  Optimizing sampling rate of P&O MPPT technique , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[11]  Milan M. Jovanovic,et al.  A design approach for server power supplies for networking applications , 2000, APEC 2000. Fifteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.00CH37058).

[12]  Roger Gules,et al.  An interleaved boost DC-DC converter with large conversion ratio , 2003, 2003 IEEE International Symposium on Industrial Electronics ( Cat. No.03TH8692).

[13]  Xuefeng Hu,et al.  A High Voltage Gain DC–DC Converter Integrating Coupled-Inductor and Diode–Capacitor Techniques , 2014, IEEE Transactions on Power Electronics.

[14]  Yuanmao Ye,et al.  Quadratic boost converter with low buffer capacitor stress , 2014 .

[15]  Fred C. Lee,et al.  High-efficiency, high step-up DC-DC converters , 2003 .

[16]  Luis Martinez-Salamero,et al.  Efficiency analysis of a sliding-mode controlled quadratic boost converter , 2013 .

[17]  R.P. Torrico-Bascope,et al.  A High Step-Up DC-DC Converter Based on Three-State Switching Cell , 2006, 2006 IEEE International Symposium on Industrial Electronics.

[18]  Ernane Antônio Alves Coelho,et al.  A quasi-resonant quadratic boost converter using a single resonant network , 2005, IEEE Transactions on Industrial Electronics.

[19]  Rong-Jong Wai,et al.  High step-up converter with coupled-inductor , 2005 .

[20]  Ebrahim Babaei,et al.  Interleaved high step-up DC–DC converter based on three-winding high-frequency coupled inductor and voltage multiplier cell , 2015 .

[21]  Jiann-Fuh Chen,et al.  High-Conversion-Ratio Bidirectional DC–DC Converter With Coupled Inductor , 2014, IEEE Transactions on Industrial Electronics.

[22]  Y. Lembeye,et al.  Optimization and Design of a Cascaded DC/DC Converter Devoted to Grid-Connected Photovoltaic Systems , 2012, IEEE Transactions on Power Electronics.

[23]  Carlos Andrés Ramos-Paja,et al.  Maximum power point tracking architectures for photovoltaic systems in mismatching conditions: a review , 2014 .

[24]  Wuhua Li,et al.  Review of Nonisolated High-Step-Up DC/DC Converters in Photovoltaic Grid-Connected Applications , 2011, IEEE Transactions on Industrial Electronics.

[25]  Suleiman M. Sharkh,et al.  Design and Control of a Grid-Connected Interleaved Inverter , 2013 .

[26]  Paulo P. Praca,et al.  Soft switching high-voltage gain dc-dc interleaved boost converter , 2015 .

[27]  Luis Martinez-Salamero,et al.  Synthesis of Canonical Elements for Power Processing in DC Distribution Systems Using Cascaded Converters and Sliding-Mode Control , 2014, IEEE Transactions on Power Electronics.

[28]  Amod C. Umarikar,et al.  High step-up pulse-width modulation DC–DC converter based on quasi-Z-source topology , 2015 .

[29]  Yungtaek Jang,et al.  Interleaved Boost Converter With Intrinsic Voltage-Doubler Characteristic for Universal-Line PFC Front End , 2007, IEEE Transactions on Power Electronics.

[30]  C.M.T. Cruz,et al.  A new isolated DC-DC boost converter using three-state switching cell , 2008, 2008 Twenty-Third Annual IEEE Applied Power Electronics Conference and Exposition.

[31]  Francisco Jurado,et al.  Novel topology for DC/DC unidirectional converter for fuel cell , 2014 .

[32]  Ivo Barbi,et al.  Generation of a family of non-isolated DC-DC PWM converters using new three-state switching cells , 2000, 2000 IEEE 31st Annual Power Electronics Specialists Conference. Conference Proceedings (Cat. No.00CH37018).

[33]  R. Haroun,et al.  Synthesis of a power gyrator based on sliding mode control of two cascaded boost converters using a single sliding surface , 2013, 10th International Multi-Conferences on Systems, Signals & Devices 2013 (SSD13).

[34]  Jafar Milimonfared,et al.  High step-up DC–DC converter with ripple free input current and soft switching , 2014 .

[35]  Shih-Ming Chen,et al.  A Cascaded High Step-Up DC–DC Converter With Single Switch for Microsource Applications , 2011, IEEE Transactions on Power Electronics.

[36]  M. Vitelli,et al.  Optimizing duty-cycle perturbation of P&O MPPT technique , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[37]  Rong-Jong Wai,et al.  High-Performance Stand-Alone Photovoltaic Generation System , 2008, IEEE Transactions on Industrial Electronics.

[38]  Ebrahim Babaei,et al.  Analysis of voltage and current stresses of a generalised step-up DC-DC converter , 2014 .

[39]  M. Vitelli,et al.  Guidelines for the Optimization of the P&O Technique in Grid-connected Double-stage Photovoltaic Systems , 2007, 2007 IEEE International Symposium on Industrial Electronics.