Optical fiber strain and temperature sensor based on an in-line Mach–Zehnder interferometer using thin-core fiber

Abstract We propose and demonstrate a fiber in-line Mach–Zehnder interferometer using thin-core fibers. This in-line interferometer is composed of a short section of thin-core fiber inserted between two single mode fibers (SMF), and demonstrated as a strain and temperature sensor in this study. A strain sensitivity of −1.83 pm/μe with a measurement range of 0−2000 μe, and the temperature sensitivity of −72.89 pm/°C with a temperature variation of 50 °C are achieved. We also discussed that the influence of strain and temperature change on the relative power ratios among the excited cladding modes in thin-core fibers.

[1]  S. Akturk,et al.  Direct generation of 81 nJ pulses and external compression to a subpicosecond regime with a 4.9 MHz chirped-pulse multipass-cavity Cr⁴⁺:forsterite oscillator. , 2011, Optics letters.

[2]  Wenjun Zhou,et al.  Simultaneous measurement of curvature and temperature based on PCF-based interferometer and fiber Bragg grating , 2011 .

[3]  A. Zhang,et al.  Fiber-optic refractive-index sensors based on transmissive and reflective thin-core fiber modal interferometers , 2010 .

[4]  J. Meunier,et al.  Strain and Temperature Sensing Characteristics of Single-Mode–Multimode–Single-Mode Structures , 2009, Journal of Lightwave Technology.

[5]  H. Tsai,et al.  High sensitivity of taper-based Mach-Zehnder interferometer embedded in a thinned optical fiber for refractive index sensing. , 2011, Applied optics.

[6]  Zhaobing Tian,et al.  Single-Mode Fiber Refractive Index Sensor Based on Core-Offset Attenuators , 2008, IEEE Photonics Technology Letters.

[7]  J. Canning,et al.  Modal interferometer for in situ measurements of induced core index change in optical fibers. , 1997, Optics letters.

[8]  Zhaobing Tian,et al.  Refractive Index Sensing With Mach–Zehnder Interferometer Based on Concatenating Two Single-Mode Fiber Tapers , 2008, IEEE Photonics Technology Letters.

[9]  D. A. May-Arrioja,et al.  Robust 2 × 2 Multimode Interference Optical Switch , 2006 .

[10]  J. Sirkis.  Unified approach to phase-strain-temperature models for smart structure interferometric optical fiber sensors: part 1, development , 1993 .

[11]  Yuehua Wu,et al.  All-Fiber Curvature Sensor Based on Multimode Interference , 2011, IEEE Photonics Technology Letters.

[12]  Sailing He,et al.  Low-cost high-performance fiber-optic pH sensor based on thin-core fiber modal interferometer. , 2009, Optics express.

[13]  Li Wei,et al.  Simultaneous measurement for strain and temperature using fiber Bragg gratings and multimode fibers. , 2008, Applied optics.

[14]  Tao Wei,et al.  Fiber Inline Core–Cladding-Mode Mach–Zehnder Interferometer Fabricated by Two-Point CO$_{2}$ Laser Irradiations , 2009, IEEE Photonics Technology Letters.

[15]  Yuliya Semenova,et al.  Bent SMS fibre structure for temperature measurement , 2010 .

[16]  Li Wei,et al.  Low-cost high-sensitivity strain and temperature sensing using graded-index multimode fibers. , 2007, Applied optics.

[17]  Sailing He,et al.  Fiber-Optic High-Temperature Sensor Based on Thin-Core Fiber Modal Interferometer , 2010, IEEE Sensors Journal.

[18]  Bo Dong,et al.  Core-offset hollow core photonic bandgap fiber-based intermodal interferometer for strain and temperature measurements. , 2011, Applied optics.

[19]  Jose Javier Sanchez-Mondragon,et al.  A reconfigurable multimode interference splitter for sensing applications , 2007 .