Optimization of Joined-Wing Aircraft

The joined wing is an innovative aircraft configuration with a rear wing that has its root attached near the top of the vertical tail and a tip that sweeps forward to join the trailing edge of the main wing. This study demonstrates the application of numerical optimization to aircraft design and presents a quantitative comparison of joined-wing and conventional aircraft designed for the same medium-range transport mission. The computer program developed for this study used a vortex-lattice model of the complete aircraft to estimate aerodynamic performance, and a beam model of the lifting-surface structure to calculate wing and tail weight. Weight estimation depended on a fully stressed design algorithm that included a constraint on buckling and a correlation with a statistically based method for total lifting-surface weight. A variety of "optimum" joined-wing and conventional aircraft designs are compared on the basis of direct operating cost, gross weight, and cruise drag. Maximum lift and horizontal tail buckling were identified as critical joined-wing design issues. The addition of a buckling constraint is shown to decrease the optimum joined-wing span and increase direct operating cost by about 4%. The most promising joined-wing designs were found to have a joint location at about 70% of the wing semispan, a fuel tank in the tail to trim, and a flap spanning 70% of the wing. These designs are shown to cost 3% more to operate than a conventional configuration designed for the same medium-range mission.

[1]  Julian Wolkovitch,et al.  Parametric weight evaluation of joined wings by structural optimization , 1988 .

[2]  R. De Filippo,et al.  Aircraft synthesis using numerical optimization methodology , 1983 .

[3]  Thomas L. Galloway,et al.  Computer Aided Parametric Analysis for General Aviation Aircraft , 1973 .

[4]  Prabhat Hajela,et al.  Reduced complexity structural modeling for automated airframe synthesis , 1987 .

[5]  J. Letcher.  V-Wings and Diamond Ring-Wings of Minimum Induced Drag , 1972 .

[6]  D. L. Trapp,et al.  Parametric study of transport aircraft systems cost and weight , 1977 .

[7]  Mary Fairchild Samuels.  Structural Weight Comparison of a Joined Wing and a Conventional Wing , 1982 .

[8]  Richard W. Hamming,et al.  Numerical Methods for Scientists and Engineers , 1963 .

[9]  P. Gill,et al.  Fortran package for nonlinear programming. User's Guide for NPSOL (Version 4. 0) , 1986 .

[10]  Michael A. Saunders,et al.  User''s guide for NPSOL (Ver-sion 4.0): A FORTRAN package for nonlinear programming , 1984 .

[11]  Ilan Kroo,et al.  Aerodynamic and structural studies of joined-wing aircraft , 1991 .

[12]  T. Kármán,et al.  Turbulence and Skin Friction , 1934 .

[13]  Richard Shepherd Shevell,et al.  Fundamentals of Flight , 1983 .

[14]  J. Wolkovitch,et al.  The joined wing - An overview , 1985 .

[15]  Philip E. Gill,et al.  Practical optimization , 1981 .

[16]  J. P. Lasalle,et al.  Stability and Control , 1962 .

[17]  E. Torenbeek,et al.  Synthesis of Subsonic Airplane Design , 1979 .