Flow characteristics of a centrifugal pump
暂无分享,去创建一个
Measurements of velocity have been obtained in a centrifugal pump in terms of angle-resolved values in the impeller passages, the volute, the inlet and exit ducts and are presented in absolute and relative frames. The pump comprised a radial flow impeller with four backswept blades and a single volute, and the working liquid had the same refractive index as the transparent casing to facilitate the use of a laser-Doppler velocimeter. The flows in the impeller passages wee found to depart from the curvature of the blade surfaces at off-design conditions with separation from the suction surface and from the shroud. Secondary flows from the suction to pressure surfaces were dominated by the influences of the relative motion between the shroud and impeller surfaces and the tip leakage. Geometric differences of 0.5 mm and one degree in spacing of the four blades caused differences in passage velocity of up to 6 percent at the lowest discharge. The flowrate from each impeller passage varied with volute circumferential position by up to 25 percent at an off-design flowrate. Poor matching of the impeller and volute at off-design conditions caused swirl and separation in the inlet and exit pipes.