Design considerations and calibration of stress transducers for soil

Strain gage pressure transducers are most frequently used for soil stress state determinations. Their construction, rugged and mechanically resistant, enables them to measure stresses within a wide range (up to 500 kPa) in harsh conditions. Output signals are easily readable and stable. The accuracy of the measurements, however, depends upon proper design and calibration before use in soil. This paper contains information on design considerations and results from calibration tests of transducers of two membrane diameters: 20 and 30 mm. The calibration test stand, as well as calibration procedures, are described in detail. For calibration tests, natural soils were used, as well as steel balls, to simulate the effect of the aggregated structures of arable soils and grain materials. The calibration method considered different soil types as well as soil water content. Soil and its water content were found to have an effect on output scale factor.

[1]  Jaroslaw Pytka,et al.  Soil stress and deformation determination under a landing airplane on an unsurfaced airfield , 2003 .

[2]  K. Konstankiewicz,et al.  A new optical method for soil stress and strain investigation , 2002 .

[3]  Jaroslaw Pytka,et al.  Advantages of all-season versus snow tyres for off-road traction and soil stresses , 2006 .

[4]  H. Harris,et al.  A soil stress transducer for measuring in situ soil stresses , 1994 .

[5]  Jaroslaw Pytka,et al.  Determination of the stress–strain relationship for sandy soil in field experiments , 2001 .

[6]  Eddie C. Burt,et al.  The effects of reduced inflation pressure on soil-tire interface stresses and soil strength , 1995 .

[7]  Eddie C. Burt,et al.  SOIL STRESSES UNDER A TRACTOR TIRE AT VARIOUS LOADS AND INFLATION PRESSURES , 1996 .

[8]  Randall C. Reeder,et al.  Measuring and predicting Stress Distribution under Tractive Devices in Undisturbed Soils , 2003 .

[9]  Jaroslaw Pytka,et al.  Effects of repeated rolling of agricultural tractors on soil stress and deformation state in sand and loess , 2005 .

[10]  Jaroslaw Pytka,et al.  Effects of reduced inflation pressure and vehicle loading on off-road traction and soil stress and deformation state , 2006 .

[11]  K. Y. Wong,et al.  Measurement of Stress Paths under Agricultural Vehicles and their Interpretation in Critical State Space , 1995 .

[12]  Timothy A. Nichols,et al.  A Stress State Transducer for Soil , 1987 .

[13]  A. Bailey,et al.  A Pressure Transducer in Soil Compaction Study , 1976 .