The effect of corona discharge on free convection heat transfer from a horizontal cylinder

Abstract Free convection heat transfer from an isothermal horizontal cylinder in the presence of DC positive corona discharge with a blade edge emitter electrode has been studied experimentally and numerically. A Mach–Zehnder interferometer was used to determine the local Nusselt numbers. The effect of corona discharge on heat transfer from the cylinder was investigated at Rayleigh numbers in the range between 1500 and 5000. To find the details of the flow patterns and to further verify the experimental results, numerical simulations were also performed. It was found that the numerical results are in good agreement with experimental data. By increasing the applied voltage up to 15.5 kV, the corona discharge generates a recirculation zone around the blade and below the lower stagnation point of the cylinder. The effect of the recirculation zone becomes stronger near the breakdown voltage (17 kV) and it is responsible for a local decrease in the cooling of the cylinder around the lower stagnation point. The results indicate that corona discharge has a significant effect on the average Nusselt number at lower Rayleigh numbers whereas it has smaller effect at higher Rayleigh numbers.

[1]  Takeo S. Saitoh,et al.  Bench mark solutions to natural convection heat transfer problem around a horizontal circular cylinder , 1993 .

[2]  Melba Phillips,et al.  Classical Electricity and Magnetism , 1955 .

[3]  B. Owsenek,et al.  Theoretical and Experimental Study of Electrohydrodynamic Heat Transfer Enhancement Through Wire-Plate Corona Discharge , 1997 .

[4]  P. Wang,et al.  Numerical Computation of the Natural Convection Flow about a Horizontal Cylinder Using Splines , 1990 .

[5]  J. Mehta,et al.  Errors associated with interferometric measurement of convective heat transfer coefficients. , 1977, Applied optics.

[6]  Haim Kalman,et al.  Experimental optimization of an electric blower by corona wind , 2002 .

[7]  R. J. Goldstein,et al.  Numerical solution to the Navier-Stokes equations for laminar natural convection about a horizontal isothermal circular cylinder , 1980 .

[8]  Jamal Seyed-Yagoobi,et al.  Experimental Investigation of Corona Wind Heat Transfer Enhancement With a Heated Horizontal Flat Plate , 1995 .

[9]  Andrew J. Shine,et al.  Some Effects of an Electric Field on Heat Transfer From a Vertical Plate in Free Convection , 1967 .

[10]  Tanongkiat Kiatsiriroat,et al.  Effect of electric field on heat transfer performance of automobile radiator at low frontal air velocity , 2006 .

[11]  R. Flack,et al.  Mach-Zehnder interferometer errors resulting from test section misalignment. , 1978, Applied optics.

[12]  R. J. Goldstein,et al.  Measurements in Heat Transfer , 1976 .

[13]  Yasuo Mori,et al.  EHD study of the corona wind between wire and plate electrodes , 1978 .

[14]  M. E. Franke,et al.  Electrostatic cooling of a horizontal cylinder , 1991 .

[15]  Franz Mayinger,et al.  Wärmeübergang bei freier Konvektion um elliptische Rohre , 1984 .

[16]  Haim Kalman,et al.  Enhancement of heat transfer by means of a corona wind created by a wire electrode and confined wings assembly , 2001 .

[17]  James Q. Feng.  Application of Galerkin Finite-Element Method with Newton Iterations in Computing Steady-State Solutions of Unipolar Charge Currents in Corona Devices , 1999 .

[18]  P. Atten,et al.  Hysteresis effect of corona discharge in a narrow coaxial wire-pipe discharge tube with gas flow , 1996 .

[19]  Mehdi Ashjaee,et al.  Experimental investigation on free convection from a horizontal cylinder beneath an adiabatic ceiling , 2007 .

[20]  Tanongkiat Kiatsiriroat,et al.  Air side performance of thermosyphon heat exchanger in low Reynolds number region: with and without electric field , 2002 .

[21]  Yang Lanjun,et al.  Experimental Studies of the Enhanced Heat Transfer from a Heating Vertical Flat Plate by Ionic Wind , 2006 .

[22]  R. Moffat.  Using Uncertainty Analysis in the Planning of an Experiment , 1985 .