Line edge roughness metrology using atomic force microscopes

Line edge roughness (LER) measurements using two types of atomic force microscopes and three types of tips are compared. Measurements were made on specially prepared samples with inscribed edge roughness of different amplitudes and wavelengths. The spatial wavelengths and amplitudes each instrument was able to measure are compared. Techniques on checking the noise level of LER measuring instruments are highlighted.

[1]  Gaoliang Dai,et al.  Measurement of micro-roughness using a metrological large range scanning force microscope , 2004 .

[2]  J. Villarrubia.  Algorithms for Scanned Probe Microscope Image Simulation, Surface Reconstruction, and Tip Estimation , 1997, Journal of research of the National Institute of Standards and Technology.

[3]  C.H. Diaz,et al.  An experimentally validated analytical model for gate line-edge roughness (LER) effects on technology scaling , 2001, IEEE Electron Device Letters.

[4]  J. M. Drake,et al.  Special Issue: Dynamics of Molecular Systems , 1990 .

[5]  Surface and line-edge roughness in solution and plasma developed negative tone resists: Experiment and simulation , 2000 .

[6]  S. C. Palmateer,et al.  Comparison of metrology methods for quantifying the line edge roughness of patterned features , 1999 .

[7]  Martha I. Sanchez,et al.  Deep-ultraviolet interferometric lithography as a tool for assessment of chemically amplified photoresist performance , 1998 .

[8]  Ndubuisi G. Orji,et al.  AFM Characterization of Semiconductor Line Edge Roughness , 2004 .

[9]  P. Hansma,et al.  Atomic force microscopy , 1990, Nature.

[10]  A. Asenov,et al.  Intrinsic parameter fluctuations in decananometer MOSFETs introduced by gate line edge roughness , 2003 .

[11]  M. Meyyappan,et al.  Improved fabrication approach for carbon nanotube probe devices , 2000 .

[12]  H. Kumar Wickramasinghe,et al.  Method for imaging sidewalls by atomic force microscopy , 1994 .

[13]  Brian Osborn,et al.  Study of the fundamental contributions to line edge roughness in a 193 nm, top surface imaging system , 2000 .

[14]  Johann Foucher.  From CD to 3D sidewall roughness analysis with 3D CD-AFM , 2005, SPIE Advanced Lithography.

[15]  Gerber,et al.  Atomic Force Microscope , 2020, Definitions.

[16]  John L. Sturtevant,et al.  Experimental determination of the impact of polysilicon LER on sub-100-nm transistor performance , 2001, SPIE Advanced Lithography.

[17]  John S. Villarrubia,et al.  CD-SEM measurement line edge roughness test patterns for 193 nm lithography , 2003, SPIE Advanced Lithography.

[18]  Wenhao Huang,et al.  Numerical simulation of the geometrical factors affecting surface roughness measurements by AFM , 2004 .