Comparison and combination of imaging techniques for three dimensional analysis of electrical trees

Imaging of electrical trees has been an important tool for studying the phenomenon. The authors have previously shown that electrical trees can be three-dimensionally (3D) imaged and virtual replicas generated using X-ray Computed Tomography (XCT) or Serial Block-Face Scanning Electron Microscopy (SBFSEM). Here these techniques are evaluated and compared for 3D analysis of electrical trees along with conventional optical methods. A number of types of laboratory created trees showing range of morphologies were grown and examined to delineate the capabilities of each technique. Cross-sectional images and virtual replicas of the electrical trees from XCT and SBFSEM techniques were compared both qualitatively and quantitatively. SBFSEM provides greater detail than XCT, evidenced by imaging smaller sub-branches and when comparing parameters such as the number of tree channels, tree length or tree volume captured. On average, SBFSEM captures almost double the number of tree channels per slice than XCT, and virtual replicas in most of the cases have larger volumes. However, SBFSEM is a destructive technique, which makes the imaging process less reliable than XCT and not suitable for multi-stage of tree growth experiments. For full analysis, a combination of imaging techniques is proposed. Optical methods are used first to monitor tree growth. Then, micro-XCT which provides pixel size down to ~0.4 μm with a field of view of around 1 mm x 1 mm, can be used to reveal the overall 3D structure of a normal/mature electrical tree. Nano-XCT can be used to explore in more detail regions of interest, with a pixel size of ~65 nm, but a limited field of view of 65 μm. Finally, sections of the tree can be analyzed in even greater detail using SBFSEM, which can provide resolutions below 50 nm. Using this approach, a deeper and more complete analysis of the structure of electrical trees can be achieved.

[1]  Philip J. Withers,et al.  Imaging and analysis techniques for electrical trees using X-ray computed tomography , 2014, IEEE Transactions on Dielectrics and Electrical Insulation.

[2]  P. Withers,et al.  Quantitative X-ray tomography , 2014 .

[3]  R. Schurch,et al.  Serial block-face scanning electron microscopy for three-dimensional imaging of electrical trees , 2013, 2013 IEEE International Conference on Solid Dielectrics (ICSD).

[4]  P. Withers,et al.  Three dimensional characterisation of electrical trees , 2013, 2013 Annual Report Conference on Electrical Insulation and Dielectric Phenomena.

[5]  P. Withers,et al.  Revealing the three dimensional internal structure of aluminium alloys , 2013 .

[6]  L. A. Dissado,et al.  Effect of tree channel conductivity on electrical tree shape and breakdown in XLPE cable insulation samples , 2011, IEEE Transactions on Dielectrics and Electrical Insulation.

[7]  R. Egerton.  Physical Principles of Electron Microscopy: An Introduction to TEM, SEM, and AEM , 2010 .

[8]  Philip J. Withers,et al.  An examination of phase retrieval algorithms as applied to phase contrast tomography using laboratory sources , 2010, Optical Engineering + Applications.

[9]  M. Stampanoni,et al.  Real Time Tomography at the Swiss Light Source , 2010 .

[10]  Y. Ohki,et al.  Tree initiation time evaluation of epoxy/silica composites by partial discharge detection , 2009, 2009 IEEE 9th International Conference on the Properties and Applications of Dielectric Materials.

[11]  G. Michler.  Electron Microscopy of Polymers , 2008 .

[12]  P. Withers.  X-ray nanotomography , 2007 .

[13]  Hongtao Cui,et al.  X-ray computed tomography in Zernike phase contrast mode at 8 keV with 50-nm resolution using Cu rotating anode X-ray source , 2007 .

[14]  A. Vaughan,et al.  On the structure and chemistry of electrical trees in polyethylene , 2006 .

[15]  W. Denk,et al.  Serial Block-Face Scanning Electron Microscopy to Reconstruct Three-Dimensional Tissue Nanostructure , 2004, PLoS biology.

[16]  A. Donald,et al.  The use of environmental scanning electron microscopy for imaging wet and insulating materials , 2003, Nature Materials.

[17]  Françoise Peyrin,et al.  Observation of microstructure and damage in materials by phase sensitive radiography and tomography , 1997 .

[18]  P. Cloetens,et al.  Phase objects in synchrotron radiation hard x-ray imaging , 1996 .

[19]  Tatsuki Okamoto,et al.  The influence of morphology on electrical tree initiation in polyethylene under AC and impulse voltages , 1990 .

[20]  B. Tanner,et al.  FACTORS AFFECTING IN-LINE PHASE CONTRAST IMAGING WITH A LABORATORY MICROFOCUS X-RAY SOURCE , 2006 .

[21]  M. Glas,et al.  Principles of Computerized Tomographic Imaging , 2000 .

[22]  Practical Optics , 1946, Nature.