Application of Random PWM Technique for Reducing the Conducted Electromagnetic Emissions in Active Filters

A pulsewidth modulation (PWM)-controlled active filter generates harmonics at the switching frequency and its multiples in the RF range, and the concentrated power spectrum may produce electromagnetic interference (EMI) problems. In this paper, the random PWM (RPWM) technique is applied in order to spread the noise spectrum over a wide range, thus, considerably reducing the amplitudes of these harmonics and the consequent EMI problems. To study the operation of active filters, the case of an ac/dc converter along with a power-factor corrector is considered as a nonlinear load and a series active filter, respectively. A line impedance stabilization network is used to study the RF noise emanating from the converter. A noise model to study the EMI emission is presented and used in this paper. Theoretical analysis of the RF noise power spectrum is carried out in order to demonstrate the advantages of the RPWM technique over conventional PWM. Experimental results confirm the validity of the theoretical calculations and simulation results, and demonstrate the effectiveness of applying the RPWM technique in reducing the RF noise level.

[1]  Joachim Holtz,et al.  Total compensation of line-side switching harmonics in converter-fed AC locomotives , 1994 .

[2]  Hirofumi Akagi,et al.  A study of active power filters using quad-series voltage-source PWM converters for harmonic compensation , 1990 .

[3]  F. Mihalic,et al.  Reduced Conductive EMI in Switched-Mode DC–DC Power Converters Without EMI Filters: PWM Versus Randomized PWM , 2006, IEEE Transactions on Power Electronics.

[4]  Keiji Wada,et al.  Control Methods and Compensation Characteristics of a Series Active Filter for a Neutral Conductor , 2006, IEEE Transactions on Industrial Electronics.

[5]  J. Roudet,et al.  Conducted RFI emission from an AC-DC converter with sinusoidal line current , 1993, Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting.

[6]  J.A. Melkebeek,et al.  Input current distortion of CCM boost PFC converters operated in DCM , 2003, IEEE 34th Annual Conference on Power Electronics Specialist, 2003. PESC '03..

[7]  Hui Li,et al.  Optimized PWM strategy based on genetic algorithms , 2005, IEEE Transactions on Industrial Electronics.

[8]  Kamal Al-Haddad,et al.  An improved control algorithm of shunt active filter for voltage regulation, harmonic elimination, power-factor correction, and balancing of nonlinear loads , 2000 .

[9]  G.-H. Choe,et al.  A new injection method for AC harmonic elimination by active power filter , 1988 .

[10]  Salvador Bracho,et al.  Power-mode-controlled power-factor corrector for electronic ballast , 2005, IEEE Transactions on Industrial Electronics.

[11]  Aarnout Brombacher,et al.  Probability... , 2009, Qual. Reliab. Eng. Int..

[12]  Lei Zhang,et al.  Noise Source Lumped Circuit Modeling and Identification for Power Converters , 2006, IEEE Transactions on Industrial Electronics.

[13]  Juan Dixon,et al.  Series active power filter compensates current harmonics and voltage unbalance simultaneously , 2000 .

[14]  Bin Wang,et al.  Effects of symmetric distribution laws on spectral power density in randomized PWM , 2003, IEEE Power Electronics Letters.

[15]  Alfred Rufer,et al.  Open loop and closed loop spectral frequency active filtering , 2002 .

[16]  J. Roudet,et al.  Common mode conducted RFI emission of an AC/DC converter with sinusoidal input current , 1994 .

[17]  Pedro José Villegas,et al.  Helpful hints to select a power-factor-correction solution for low- and medium-power single-phase power supplies , 2005, IEEE Transactions on Industrial Electronics.

[18]  Andrzej M. Trzynadlowski,et al.  Analysis of power and power spectral density in PWM inverters with randomized switching frequency , 2002, IEEE Trans. Ind. Electron..

[19]  Frede Blaabjerg,et al.  Random pulse width modulation techniques for converter fed drive systems-a review , 1993, Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting.

[20]  Paolo Mattavelli,et al.  Comparison of current control techniques for active filter applications , 1998, IEEE Trans. Ind. Electron..

[21]  Hirofumi Akagi,et al.  Active Harmonic Filters , 2005, Proceedings of the IEEE.

[22]  J. T. Boys Theoretical spectra for narrow-band random PWM waveforms , 1993 .

[23]  Marian P. Kazmierkowski,et al.  Active filtering function of three-phase PWM boost rectifier under different line voltage conditions , 2005, IEEE Transactions on Industrial Electronics.

[24]  Luis Moran,et al.  A three-phase active power filter operating with fixed switching frequency for reactive power and current harmonic compensation , 1995, IEEE Trans. Ind. Electron..

[25]  G. D. Marques,et al.  An active power filter and unbalanced current compensator , 1997, IEEE Trans. Ind. Electron..

[26]  Paolo Mattavelli A closed-loop selective harmonic compensation for active filters , 2001 .

[27]  Andrzej M. Trzynadlowski,et al.  Experimental investigation of a naval propulsion drive model with the PWM-based attenuation of the acoustic and electromagnetic noise , 2006, IEEE Transactions on Industrial Electronics.

[28]  Thomas G. Habetler,et al.  Angle controlled current regulated rectifiers for AC/AC converters , 1989 .

[29]  J. Mahdavi,et al.  Comparison of conducted RFI emission from different unity power factor AC/DC converters , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.

[30]  Milan M. Jovanovic,et al.  State-of-the-art, single-phase, active power-factor-correction techniques for high-power applications - an overview , 2005, IEEE Transactions on Industrial Electronics.

[31]  Athanasios Papoulis,et al.  Probability, Random Variables and Stochastic Processes , 1965 .

[32]  Hirofumi Akagi,et al.  Trends in Active Power Line , 1994 .

[33]  P. Enjeti,et al.  Analysis and design of an active power filter for balancing unbalanced loads , 1992, PESC '92 Record. 23rd Annual IEEE Power Electronics Specialists Conference.

[34]  Andrzej M. Trzynadlowski,et al.  Advanced random pulse width modulation technique for voltage-controlled inverter drive systems , 1991, [Proceedings] APEC '91: Sixth Annual Applied Power Electronics Conference and Exhibition.

[35]  C. M. Liaw,et al.  Random slope PWM inverter using existing system background noise: analysis, design and implementation , 2000 .

[36]  S.Y.R. Hui,et al.  Microprocessor-based random PWM schemes for DC-AC power conversion , 1995, Proceedings of PESC '95 - Power Electronics Specialist Conference.

[37]  Bo-Hyung Cho,et al.  Design of fluorescent lamp ballast with PFC using a power piezoelectric transformer , 1998, APEC '98 Thirteenth Annual Applied Power Electronics Conference and Exposition.

[38]  T. Habetler,et al.  Acoustic noise reduction in sinusoidal PWM drives using a randomly modulated carrier , 1989, 20th Annual IEEE Power Electronics Specialists Conference.