Output-only modal identification of a cable-stayed bridge using wireless monitoring systems

Abstract The objective of this paper is to present two modal identification methods that extract dynamic characteristics from output-only data sets collected by a low-cost and rapid-to-deploy wireless structural monitoring system installed upon a long-span cable-stayed bridge. Specifically, an extensive program of full-scale ambient vibration testing has been conducted to measure the dynamic response of the 240 m Gi-Lu cable-stayed bridge located in Nantou County, Taiwan. Two different output-only identification methods are used to analyze the set of ambient vibration data: the stochastic subspace identification method (SSI) and the frequency domain decomposition method (FDD). A total of 10 modal frequencies and their associated mode shapes are identified from the dynamic interaction between the bridge’s cables and deck vibrations within the frequency range of 0–7 Hz. The majority of the modal frequencies observed from recording cable vibrations are also found to be associated with the deck vibrations, implying considerable interaction between the deck and cables.

[1]  Jerome P. Lynch,et al.  Embedding damage detection algorithms in a wireless sensing unit for operational power efficiency , 2004 .

[2]  Helmut Wenzel,et al.  Ambient Vibration Monitoring , 2005 .

[3]  Jerome Peter Lynch,et al.  An overview of wireless structural health monitoring for civil structures , 2007, Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences.

[4]  Bart De Moor,et al.  Subspace algorithms for the stochastic identification problem, , 1993, Autom..

[5]  Anne S. Kiremidjian,et al.  A modular, wireless damage monitoring system for structures , 1998 .

[6]  Joel P. Conte,et al.  System identification of New Carquinez bridge using ambient vibration data , 2005 .

[7]  Nicholas P. Jones,et al.  Long-term measurements on a cable-stayed bridge , 2001 .

[8]  Chia-Ming Chang,et al.  MATLAB‐based seismic response control of a cable‐stayed bridge: cable vibration , 2007 .

[9]  Yang Wang,et al.  Performance monitoring of the Geumdang Bridge using a dense network of high-resolution wireless sensors , 2006, Smart Materials and Structures.

[10]  Rune Brincker,et al.  Modal identification of output-only systems using frequency domain decomposition , 2001 .

[11]  Yi-Qing Ni,et al.  Multi-stage identification scheme for detecting damage in cable-stayed Kap Shui Mun Bridge , 2002 .

[12]  Jerome P. Lynch,et al.  A wireless structural health monitoring system with multithreaded sensing devices: design and validation , 2007 .

[13]  Guido De Roeck,et al.  REFERENCE-BASED STOCHASTIC SUBSPACE IDENTIFICATION FOR OUTPUT-ONLY MODAL ANALYSIS , 1999 .

[14]  Jerome P. Lynch,et al.  Embedment of structural monitoring algorithms in a wireless sensing unit , 2003 .

[15]  Jerome P. Lynch,et al.  Post-seismic damage assessment of steel structures instrumented with self-interrogating wireless sensors , 2006 .