Vibration suppression of boring bar by piezoelectric actuators and LR circuit

Abstract This paper presents the vibration suppression of a boring bar using piezoelectric actuators installed in the boring bar, and an inductor-resister (LR) circuit, which acts as a mechanical dynamic absorber. The frequency response function of the compliance was designed so that its real part is constrained to suppress regenerative chatter. The designed boring bar with an optimally tuned LR circuit was set on a lathe to evaluate its dynamic characteristic, and it was found that the chatter vibration was successfully suppressed in the cutting test.

[1]  Neil D. Sims,et al.  Vibration absorbers for chatter suppression: A new analytical tuning methodology , 2007 .

[2]  Etsuo Marui,et al.  Suppression of chatter vibration of boring tools using impact dampers , 2000 .

[3]  Yusuf Altintas,et al.  Optimization of multiple tuned mass dampers to suppress machine tool chatter , 2010 .

[4]  Berend Denkena,et al.  Mechatronic Systems for Machine Tools , 2007 .

[5]  Jokin Munoa,et al.  Chatter suppression in ram type travelling column milling machines using a biaxial inertial actuator , 2013 .

[6]  Keisuke Yamada,et al.  Enhancement of efficiency of vibration suppression using piezoelectric elements and LR circuit by amplification of electrical resonance , 2014 .

[7]  Manfred Weck,et al.  Chatter Stability of Metal Cutting and Grinding , 2004 .

[8]  José Fernández-Sáez,et al.  Improvement of chatter stability in boring operations with passive vibration absorbers , 2010 .

[9]  Alexander Verl,et al.  Improvement of feed drive dynamics by means of semi-active damping , 2012 .

[10]  Peter Eberhard,et al.  Adaptronic Vibration Damping for Machine Tools , 2007 .

[11]  Tetsutaro Hoshi,et al.  Stabilization of high frequency chatter vibration in fine boring by friction damper , 2001 .

[12]  Christian Brecher,et al.  Electrohydraulic Active Damping System , 2005 .

[13]  Adib A. Becker,et al.  A solution for minimising vibrations in milling of thin walled casings by applying dampers to workpiece surface , 2013 .