论文信息 - Analysis and Test of a High-Speed Axial Flux Permanent Magnet Synchronous Motor

Analysis and Test of a High-Speed Axial Flux Permanent Magnet Synchronous Motor

This paper gives the analysis and test of a surface mounted axial flux permanent magnet synchronous motor (PMSM) for a high-speed centrifugal compressor drive. Both analytical analysis and 3-D electromagnetic finite element method (FEM) are used to calculate flux density in the airgap, rotor back iron, and stator iron. 3-D FEM is used to simulate the electromotive force (back EMF) and torque. The motor has been tested up to 87,000 rpm using an open-loop controller. The advantages and disadvantages of this kind of structure are analyzed, and some improvements of this design are also considered and partially verified by experiments

[1] H. A. Leupold. Approaches to permanent magnet circuit design , 1993 .

[2] Seung-Ki Sul,et al. Implementation of sensorless vector control for super-high speed PMSM of turbo-compressor , 2001, Conference Record of the 2001 IEEE Industry Applications Conference. 36th IAS Annual Meeting (Cat. No.01CH37248).

[3] Duane C. Hanselman,et al. Brushless Permanent-Magnet Motor Design , 1994 .

[4] F. Profumo,et al. About the design of very high frequency induction motors for spindle applications , 1992, Conference Record of the 1992 IEEE Industry Applications Society Annual Meeting.

[5] Wen L. Soong,et al. Novel high speed induction motor for a commercial centrifugal compressor , 1999 .

[6] Hans-Peter Nee,et al. Analytical calculation of the airgap flux density of PM synchronous motors with buried magnets including axial leakage, tooth and yoke saturations , 2000 .

[7] W. L. Swift,et al. Design and Test of Low Capacity Reverse Brayton Cryocooler for Refrigeration at 35K and 60K , 2002 .