Detail investigation on un-stiffened T/Y tubular joints behavior under axial compressive loads

Abstract This paper presents the failure pattern, ultimate static strength and detailed behavior of un-stiffened T and Y tubular joints under axial brace compressive loading using finite element method performed by ABAQUS software package. Properties of the un-stiffened tubular joints were extracted from the available experimental-based tubular joint database. Utilizing the Modified Riks Method in numerical analyses led to an accurate simulation of joint behavior and also helped to investigate its correct failure pattern. The modes of failure observed throughout the numerical analysis were local bending of the chord member, ovalization and plastic failure of the chord. The results obtained from the numerical modeling revealed the critical areas on the joint surface with respect to ovalization, deflections and stresses. Also, the ultimate strength predicted by the numerical analysis was compared and validated with available experiment results. Despite the fact that much research has been conducted on tubular joints which have mostly focused on the estimation of ultimate strength or stress concentration factors rather than detail study of joint behavior, the present detail investigation has provided a thorough understanding of joint behavior under axial compressive loads. Such an in-depth and detail tubular joint investigation has been rarely reported in the open literature.

[1]  K. Munaswamy,et al.  Analysis of tubular joint with weld toe crack by finite element methods , 1985 .

[2]  S. P. Chiew,et al.  Static Strength of Tubular T-Joints with Reinforced Chord under Axial Compression , 2010 .

[3]  Farrel Zwerneman,et al.  22nd Edition of API RP 2A Recommended Practice for Planning, Designing and Constructing Fixed Offshore Platforms – Working Stress Design , 2010 .

[4]  Yoo Sang Choo,et al.  STATIC STRENGTH OF T-JOINTS REINFORCED WITH DOUBLER OR COLLAR PLATES. II: NUMERICAL SIMULATIONS , 2005 .

[5]  T. S. Thandavamoorthy.  Experimental and Numerical Investigations on Unstiffened Tubular T-Joints of Offshore Platforms , 2009 .

[6]  A. Llewelyn-Parry,et al.  Offshore Tubular T-Joints Reinforced with Internal Plain Annular Ring Stiffeners , 2004 .

[7]  Jaap Wardenier.  Design guide for circular hollow section (CHS) joints under predominantly static loading , 1991 .

[8]  A. G. Madhava Rao,et al.  Behavior of Internally Ring-Stiffened Joints of Offshore Platforms , 1999 .

[9]  Yoo Sang Choo,et al.  Static Strength of T-Joints Reinforced with Doubler or Collar Plates. I: Experimental Investigations , 2005 .

[10]  Ai Kah Soh,et al.  Experimental investigation of a doubler-plate reinforced tubular T-joint subjected to combined loadings , 2001 .

[11]  T. C. Fung,et al.  Ultimate Capacity of Doubler Plate–Reinforced Tubular Joints , 1999 .

[12]  Mohamad Fathi Ghanameh,et al.  Evaluation of stress concentration for planar tubular joints , 2006 .

[13]  Seng-Tjhen Lie,et al.  Fatigue Performance of Cracked Tubular T Joints under Combined Loads. II: Numerical , 2004 .