Instability, heat transfer and flow regime in a two-phase flow thermosyphon loop at different diameter evaporator channel

In this study, the influence of different channel geometries on heat transfer, flow regime and instability of a two-phase thermosyphon loop, is investigated. Instabilities in flow regime and heat transfer, at low and high heat fluxes, are observed. Bubbly flow with nucleate boiling heat transfer mechanism, confined bubbly/slug flow with backflow for small channel height (H) and finally slug/churn flow at high heat fluxes are observed. This study shows that flow and thermal instability increases as channel height (H) decreases and also heat transfer coefficient increases with increasing channel height and heat flux. Bubbly flow characterizes the flow regime at high heat transfer coefficients while confined bubbles, backflow and intermittent boiling are more significant for low channel heights with lower heat transfer coefficient and critical heat flux.

[1]  Rahmatollah Khodabandeh,et al.  An Experimental Investigation of the Influence of System Pressure on the Boiling Heat Transfer Coefficient in a Closed Two-Phase Thermosyphon Loop , 2002 .

[2]  Rahmatollah Khodabandeh.  Pressure drop in riser and evaporator in an advanced two-phase thermosyphon loop , 2005 .

[3]  Rahmatollah Khodabandeh,et al.  Thermal performance of a closed advanced two-phase thermosyphon loop for cooling of radio base stations at different operating conditions , 2004 .

[4]  P. Kew,et al.  Correlations for the prediction of boiling heat transfer in small-diameter channels , 1997 .

[5]  Rahmatollah Khodabandeh,et al.  Choosing Working Fluid for Two-Phase Thermosyphon Systems for Cooling of Electronics , 2003 .

[6]  Pallippattu Krishnan Vijayan,et al.  Analytical study of nuclear-coupled density-wave instability in a natural circulation pressure tube type boiling water reactor , 2000 .

[7]  Rahmatollah Khodabandeh.  Heat transfer in the evaporator of an advanced two-phase thermosyphon loop , 2005 .

[8]  Michitsugu Mori,et al.  Fundamental Study on Thermo-Hydraulics during Start-Up in Natural Circulation Boiling Water Reactors, (II) , 1993 .

[9]  D.D.B. van Bragt,et al.  Reactor experiments on type-I and type-II BWR stability , 2000 .

[10]  T. V. D. Hagen,et al.  Flashing-induced density wave oscillations in a natural circulation BWR—mechanism of instability and stability map , 2005 .

[11]  Danny Lathouwers,et al.  A numerical study of boiling flow instability of a reactor thermosyphon system , 2006 .

[12]  Michitsugu Mori,et al.  Geysering in parallel boiling channels , 1993 .

[13]  T. V. D. Hagen,et al.  Experimental thermohydraulic stability map of a Freon-12 boiling water reactor facility with high exit friction , 2004 .

[14]  Kenji Fukuda,et al.  Classification of two-phase flow instability by density wave oscillation model. , 1979 .

[15]  Lounes Tadrist,et al.  Experimental study of unsteady convective boiling in heated minichannels , 2003 .

[16]  Lounes Tadrist,et al.  Review on two-phase flow instabilities in narrow spaces , 2007 .

[17]  Pallippattu Krishnan Vijayan,et al.  Study on the stability behaviour of a natural circulation pressure tube type boiling water reactor , 2002 .