Lateral force microscopy using acoustic friction force microscopy

Conventional friction force microscopy (FFM) is widely used for tribological studies of engineering surfaces. It is, however, difficult to separate friction forces resulting from interactions dependent upon interfacial material properties from surface topography-induced lateral forces. We have developed and employed a technique to operate acoustic friction force microscopy (AFFM) by oscillating the sample laterally at megahertz frequencies. The in-plane vibrations perpendicular to the longitudinal axis of the cantilever are generated because of lateral forces between the probe tip and the sample. Torsional cantilever vibrations were detected at frequencies of up to 2 MHz. A mean cantilever lift-off was observed that can be explained by elastohydrodynamic lubrication. The high-frequency torsional vibration amplitude provides information about the lateral forces that can be used to calculate the friction and viscosity of thin surface films. The AFFM images of metal-particle magnetic tapes were produced, revealing a resolution apparently better than FFM images. Unlike FFM images, AFFM images are independent of the scanning direction, indicating that AFFM images are less sensitive to topography-induced lateral forces. Also, AFFM, allows friction measurements at relative velocities of the order of 1 mm s −1 which is much larger than that obtained in conventional FFM (several μm s−1). Copyright © 1999 John Wiley & Sons, Ltd.

[1]  S. Stepnowski,et al.  Viscoelastic effects in nanometer‐scale contacts under shear , 1998 .

[2]  Kazushi Yamanaka,et al.  Quantitative elasticity evaluation by contact resonance in an atomic force microscope , 1998 .

[3]  W. Arnold,et al.  Theoretical description of the transfer of vibrations from a sample to the cantilever of an atomic force microscope , 1997 .

[4]  Robert W. Carpick,et al.  Calibration of frictional forces in atomic force microscopy , 1996 .

[5]  Ute Rabe,et al.  Vibrations of free and surface‐coupled atomic force microscope cantilevers: Theory and experiment , 1996 .

[6]  A. Baró,et al.  Lock‐in technique for measuring friction on a nanometer scale , 1996 .

[7]  Pascal Gallo,et al.  Scanning local‐acceleration microscopy , 1996 .

[8]  K. Yamanaka,et al.  Lateral Force Modulation Atomic Force Microscope for Selective Imaging of Friction Forces , 1995 .

[9]  C. Heiden,et al.  A lateral modulation technique for simultaneous friction and topography measurements with the atomic force microscope , 1994 .

[10]  B. Bhushan,et al.  Atomic-Scale Friction Measurements Using Friction Force Microscopy. Part 1. General Principles and New Measurement Techniques , 1994 .

[11]  Ute Rabe,et al.  Acoustic microscopy by atomic force microscopy , 1994 .

[12]  Oleg Kolosov,et al.  Ultrasonic force microscopy for nanometer resolution subsurface imaging , 1994 .

[13]  Oleg Kolosov,et al.  Nonlinear Detection of Ultrasonic Vibrations in an Atomic Force Microscope , 1993 .

[14]  R. Neumann,et al.  The role of topography and friction for the image contrast in lateral force microscopy , 1993 .

[15]  E. Meyer,et al.  Tribological Investigations Using Friction Force Microscopy , 1993 .

[16]  N. Amer,et al.  Simultaneous measurement of lateral and normal forces with an optical‐beam‐deflection atomic force microscope , 1990 .

[17]  W. Arnold,et al.  Experimental study of laser-generated shear waves using interferometry , 1990 .

[18]  J. W. Wagner,et al.  Optical sensing of in‐plane ultrasonic transients , 1988 .

[19]  G. McClelland,et al.  Atomic-scale friction of a tungsten tip on a graphite surface. , 1987, Physical review letters.

[20]  B. Bhushan,et al.  Active Friction Control Using Ultrasonic Vibration , 1998 .

[21]  B. Hamrock,et al.  Fundamentals of Fluid Film Lubrication , 1994 .

[22]  Y. Akahama,et al.  Structural Phase Transitions in Selenium up to 150 GPa , 1993 .