Detectability of Delamination in Concrete Structure Using Active Infrared Thermography in Terms of Signal-to-Noise Ratio

Detecting subsurface delamination is a difficult and vital task to maintain the durability and serviceability of concrete structure for its whole life cycle. The aim of this work was to obtain better knowledge of the effect of depth, heating time, and rebar on the detectability capacity of delamination. Experimental tests were carried out on a concrete specimen in the laboratory using Long Pulsed Thermography (LPT). Six halogen lamps and a long wavelength infrared camera with a focal plane array of 640 × 480 pixels were used as the heat source and infrared detector, respectively. The study focused on the embedded imitation delaminations with the size of 10 cm × 10 cm × 1 cm, located at depths varying from 1 to 8 cm. The signal-to-noise ratio (SNR) was applied as a criterion to assess the detectability of delamination. The results of this study indicate that as the provided heating time climbed, the SNR increased, and the defect could be identified more clearly. On the other hand, when using the same heating regime, a shallow delamination displayed a higher SNR than a deeper one. The moderate fall of the SNR in the case of imitating defect located below reinforced steel was also observed. The absolute contrast was monitored to determine the observation time, and the nondimensional prefactor k was empirically proposed to predict the depth of delamination. The mean absolute percentage error (MAPE) was used to quantitatively evaluate the difference between forecasted and real depth, which evaluation confirmed the high reliability of the estimated value of the prefactor k.

[1]  Jungwon Huh,et al.  Effects of rebars on the detectability of subsurface defects in concrete bridges using square pulse thermography , 2018, NDT & E International.

[2]  Adolfo Cobo,et al.  Signal to noise ratio (SNR) comparison for pulsed thermographic data processing methods applied to welding defect detection , 2010 .

[3]  Herbert Wiggenhauser,et al.  Intestigation of concrete structures with pulse phase thermography , 2005 .

[4]  C. Lewis,et al.  Demand Forecasting and Inventory Control: A Computer Aided Learning Approach , 1998 .

[5]  Xavier Maldague,et al.  Applications of infrared thermography in nondestructive evaluation , 2000 .

[6]  S. Marinetti,et al.  Pulse phase infrared thermography , 1996 .

[7]  Jose Miguel Lopez-Higuera,et al.  Signal to noise ratio (SNR) comparison for lock-in thermographic data processing methods in CFRP specimen , 2010 .

[8]  Xavier Maldague,et al.  Theory and Practice of Infrared Technology for Nondestructive Testing , 2001 .

[9]  P. Venegas,et al.  A quantitative comparison of stimulation and post-processing thermographic inspection methods applied to aeronautical carbon fibre reinforced polymer , 2012 .

[10]  Darryl P Almond,et al.  An analytical study of the pulsed thermography defect detection limit , 2012 .

[11]  M. Maj,et al.  Reconstruction of size and depth of simulated defects in austenitic steel plate using pulsed infrared thermography , 2012 .

[12]  H. R. Hamilton,et al.  Heating Methods and Detection Limits for Infrared Thermography Inspection of Fiber-Reinforced Polymer Composites , 2007 .

[13]  Achintya Haldar,et al.  Effects of Ambient Temperature and Relative Humidity on Subsurface Defect Detection in Concrete Structures by Active Thermal Imaging , 2017, Sensors.

[14]  Cory A. Larsen.  Document Flash Thermography , 2011 .

[15]  Bernd Hillemeier,et al.  Application of impulse-thermography for non-destructive assessment of concrete structures , 2006 .

[16]  Ikhlas Abdel-Qader,et al.  Segmentation of thermal images for non-destructive evaluation of bridge decks , 2008 .

[17]  P. Venegas,et al.  Non-destructive inspection of drilled holes in reinforced honeycomb sandwich panels using active thermography , 2012 .

[18]  Jungwon Huh,et al.  Experimental Study on Detection of Deterioration in Concrete Using Infrared Thermography Technique , 2016 .

[19]  Julio Molleda,et al.  Infrared Thermography for Temperature Measurement and Non-Destructive Testing , 2014, Sensors.

[20]  Herbert Wiggenhauser,et al.  Transient thermography for structural investigation of concrete and composites in the near surface region , 2002 .

[21]  Jose Miguel Lopez-Higuera,et al.  Quantification by Signal to Noise Ratio of Active Infrared Thermography Data Processing Techniques , 2013 .

[22]  Jungwon Huh,et al.  Detectability of Subsurface Defects with Different Width-to-Depth Ratios in Concrete Structures Using Pulsed Thermography , 2018 .

[23]  Theresa M. Ahlborn,et al.  Evaluation of Bridge Decks using Non-Destructive Evaluation (NDE) at Near Highway Speeds for Effective Asset Management , 2015 .

[24]  Khatereh Vaghefi,et al.  Infrared Thermography Enhancements for Concrete Bridge Evaluation , 2013 .

[25]  Koji Mitani,et al.  A Review of Field Implementation of Infrared Thermography as a Non-destructive Evaluation Technology , 2014 .

[26]  Vlatko Bosiljkov,et al.  Determination of the applicability and limits of void and delamination detection in concrete structures using infrared thermography , 2015 .

[27]  J. Skála,et al.  Quantitative evaluation of active thermography using contrast-to-noise ratio. , 2018, Applied optics.

[28]  Ralf Arndt,et al.  Influence of concrete properties on the detection of voids with impulse-thermography , 2007 .

[29]  Ivana Banjad Pečur,et al.  Detecting defects in reinforced concrete using the method of infrared thermography , 2014 .

[30]  Jared Eric Kretzmann.  Evaluating the industrial application of non-destructive inspection of composites using transient thermography , 2016 .

[31]  G. Planinšič.  Infrared Thermal Imaging: Fundamentals, Research and Applications , 2011 .

[32]  X. Maldague.  Nondestructive Evaluation of Materials by Infrared Thermography , 1993 .

[33]  Ivana Banjad Pecur,et al.  Review of Active IR Thermography for Detection and Characterization of Defects in Reinforced Concrete , 2016, J. Imaging.

[34]  Chih-Hung Chiang,et al.  Defect detection of concrete structures using both infrared thermography and elastic waves , 2008 .