Salt Concentration Differences Alter Membrane Resistance in Reverse Electrodialysis Stacks

Membrane ionic resistance is usually measured by immersing the membrane in a salt solution at a single, fixed concentration. While salt concentration is known to affect membrane resistance when the same concentration is used on both sides of the membrane, little is known about membrane resistance when the membrane is placed between solutions of different concentrations, such as in a reverse electrodialysis (RED) stack. Ionic resistance measurements obtained using Selemion CMV and AMV that separated sodium chloride and ammonium bicarbonate solutions of different concentrations were greater than those measured using only the high-concentration solution. Measured RED stack resistances showed good agreement with resistances calculated using an equivalent series resistance model, where the membranes accounted for 46% of the total stack resistance. The high area resistance of the membranes separating different salt concentration solutions has implications for modeling and optimizing membranes used in RED systems.

[1]  J. Post,et al.  Energy recovery from controlled mixing salt and fresh water with a reverse electrodialysis system. , 2008, Environmental science & technology.

[2]  Matthias Wessling,et al.  Ion conductive spacers for increased power generation in reverse electrodialysis , 2010 .

[3]  J. Veerman,et al.  Reverse electrodialysis: A validated process model for design and optimization , 2011 .

[4]  Matthias Wessling,et al.  Transport limitations in ion exchange membranes at low salt concentrations , 2010 .

[5]  J. Post,et al.  Salinity-gradient power : Evaluation of pressure-retarded osmosis and reverse electrodialysis , 2007 .

[6]  S. S. Madaeni,et al.  The Electrochemical Characterization of Ion Exchange Membranes in Different Electrolytic Environments: Investigation of Concentration and pH Effects , 2012 .

[7]  Bruce E Logan,et al.  Energy Capture from Thermolytic Solutions in Microbial Reverse-Electrodialysis Cells , 2012, Science.

[8]  W. M. Haynes.  CRC Handbook of Chemistry and Physics , 1990 .

[9]  H. Strathmann,et al.  Introduction to Membrane Science and Technology , 2011 .

[10]  B. Logan,et al.  Ionic resistance and permselectivity tradeoffs in anion exchange membranes. , 2013, ACS applied materials & interfaces.

[11]  B. Logan,et al.  Evaluation of flow fields on bubble removal and system performance in an ammonium bicarbonate reverse electrodialysis stack , 2013 .

[12]  Benny D. Freeman,et al.  Fundamental water and salt transport properties of polymeric materials , 2014 .

[13]  Matthias Wessling,et al.  Current status of ion exchange membranes for power generation from salinity gradients , 2008 .

[14]  Matthias Wessling,et al.  Practical potential of reverse electrodialysis as process for sustainable energy generation. , 2009, Environmental science & technology.

[15]  Dc Kitty Nijmeijer,et al.  Anion exchange membranes for alkaline fuel cells: A review , 2011 .

[16]  T. Xu.  Ion exchange membranes: State of their development and perspective , 2005 .

[17]  M. Elimelech,et al.  Membrane-based processes for sustainable power generation using water , 2012, Nature.

[18]  Enver Guler,et al.  Tailor-made anion-exchange membranes for salinity gradient power generation using reverse electrodialysis. , 2012, ChemSusChem.

[19]  B. Logan,et al.  Ammonium Bicarbonate Transport in Anion Exchange Membranes for Salinity Gradient Energy. , 2013, ACS macro letters.

[20]  G. J. Harmsen,et al.  Reverse electrodialysis: Comparison of six commercial membrane pairs on the thermodynamic efficiency and power density , 2009 .

[21]  Kitty Nijmeijer,et al.  Doubled power density from salinity gradients at reduced intermembrane distance. , 2011, Environmental science & technology.