Effect of photoinitiator level on properties of a light-cured and post-cure heated model resin system.

[1]  G. Schuster,et al.  Effect of Heating Delay on Conversion and Strength of a Post-cured Resin Composite , 1998, Journal of dental research.

[2]  F. Rueggeberg,et al.  Time-temperature profiles of post-cure composite ovens. , 1998, General dentistry.

[3]  E. Greener,et al.  Effect of photoinitiator on degree of conversion of unfilled light-cured resin. , 1994, Journal of dentistry.

[4]  P. Burtscher.  Stability of radicals in cured composite materials. , 1993, Dental materials : official publication of the Academy of Dental Materials.

[5]  W. Gregory,et al.  Physical properties and repair bond strength of direct and indirect composite resins. , 1992, The Journal of prosthetic dentistry.

[6]  D. Covey,et al.  Mechanical properties of heat-treated composite resin restorative materials. , 1992, The Journal of prosthetic dentistry.

[7]  J L Ferracane,et al.  Post-cure heat treatments for composites: properties and fractography. , 1992, Dental materials : official publication of the Academy of Dental Materials.

[8]  C. Fairhurst,et al.  The effect of glaze on porcelain strength. , 1992, Dental materials : official publication of the Academy of Dental Materials.

[9]  A. Peutzfeldt,et al.  Mechanical properties of heat treated restorative resins for use in the inlay/onlay technique. , 1990, Scandinavian journal of dental research.

[10]  F. Rueggeberg,et al.  Calibration of FTIR conversion analysis of contemporary dental resin composites. , 1990, Dental materials : official publication of the Academy of Dental Materials.

[11]  C. Davidson,et al.  Annealing as a mechanism of increasing wear resistance of composites. , 1990, Dental materials : official publication of the Academy of Dental Materials.

[12]  D. Watts,et al.  Dynamic mechanical properties of an inlay composite. , 1989, Journal of dentistry.

[13]  W. J. O'brien,et al.  Dental materials : properties and selection , 1989 .

[14]  Wendt Sl.  The effect of heat used as a secondary cure upon the physical properties of three composite resins. I. Diametral tensile strength, compressive strength, and marginal dimensional stability. , 1987 .

[15]  J. Ferracane,et al.  Fourier Transform Infrared Analysis of Degree of Polymerization in Unfilled Resins—Methods Comparison , 1984, Journal of dental research.

[16]  Wen-Li Wu,et al.  Post-curing of dental restorative resin , 1983 .

[17]  C. Davidson,et al.  The influence of temperature on some physical properties of dental composites. , 1981, Journal of oral rehabilitation.

[18]  S. Svendsen,et al.  Remaining methacrylate groups in composite restorative materials. , 1978, Acta odontologica Scandinavica.

[19]  Fred W. Billmeyer,et al.  Textbook Of Polymer Science , 1971 .