A novel CMOS out-of-plane accelerometer with fully differential gap-closing capacitance sensing electrodes

This study presents a novel CMOS-MEMS out-of-plane linear accelerometer. This capacitance-type accelerometer contains specially designed gap-closing sensing electrode arrays with on-chip fully differential sensing circuits. Moreover, the comb-finger electrodes have the characteristics of the high fill factor and sub-micron gap to increase the sensing capacitance. Thus, the sensitivity and signal-to-noise ratio can be further improved. This study has established a post-CMOS wet-etching process to realize the accelerometer with sensing electrodes of the sub-micron gap in the out-of-plane direction. The present accelerometer has been demonstrated using the standard TSMC 2P4M process plus the post-release technique. The measurement results demonstrate that the accelerometer has a sensitivity of 1.14 mV g −1 , and a nonlinearity of 3.4%. (Some figures in this article are in colour only in the electronic version)

[1]  Bernhard E. Boser,et al.  A three-axis micromachined accelerometer with a CMOS position-sense interface and digital offset-trim electronics , 1999, IEEE J. Solid State Circuits.

[2]  Gary K. Fedder,et al.  Design and fabrication of an integrated CMOS-MEMS 3-axis accelerometer , 2003 .

[3]  H. Seidel,et al.  A Piezoresistive Silicon Accelerometer With Monolithically Integrated CMOS-circuitry , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[4]  Makoto Ishida,et al.  Three-axis SOI capacitive accelerometer with PLL C-V converter , 1999 .

[5]  K. Najafi,et al.  A monolithic three-axis micro-g micromachined silicon capacitive accelerometer , 2005, Journal of Microelectromechanical Systems.

[6]  Gary K. Fedder,et al.  A CMOS z-axis capacitive accelerometer with comb-finger sensing , 2000, Proceedings IEEE Thirteenth Annual International Conference on Micro Electro Mechanical Systems (Cat. No.00CH36308).

[7]  N. Sundararajan,et al.  Three-dimensional hydrodynamic focusing in polydimethylsiloxane (PDMS) microchannels , 2004, Journal of Microelectromechanical Systems.

[8]  Richard S. Payne,et al.  Surface Micromachined Accelerometer: A Technology Update , 1991 .

[9]  G. Fedder,et al.  A lateral capacitive CMOS accelerometer with structural curl compensation , 1999, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[10]  Gang Zhang,et al.  A post-CMOS micromachined lateral accelerometer , 2002 .

[11]  Gary K. Fedder,et al.  Temperature stabilization of CMOS capacitive accelerometers , 2004 .